艺术
美容与健康
工艺
文化与历史
娱乐
环境
食品与饮料
逆向工程
科学
体育
技术
可穿戴设备
Bell Telephone
Ed

创建者

Ed

28. 七月 2026FI
1
0
0
0
0

Bell Telephone

The telegraph could send a click. Sending a voice is a different problem entirely: speech is a continuously varying pressure wave, and a click is a switch. You cannot build a voice out of on and off, however fast you go.

The answer is to stop switching and start varying. A membrane moves with the sound pressure, that motion varies a current continuously, and at the far end the varying current pulls a second membrane through the same motion. Nothing is coded. The wire carries an electrical analogue of the sound wave — which is where the word analogue comes from.

The patent is titled "Improvement in Telegraphy", not telephone. US Patent 174,465, granted to Alexander Graham Bell on 7 March 1876 — arguably the most valuable and most litigated patent ever issued, and one whose priority is still argued about.

中级
6 hours

说明

1

Read US 174,465 and note the title

It is called "Improvement in Telegraphy". Bell was funded to build a multiplexed telegraph; the telephone emerged from that work and the paperwork never caught up.

所需工具:

Notebook and PencilNotebook and Pencil
2

Prove a switch cannot carry a voice

Wire a buzzer through a key and try to say a word with it. You can send code arbitrarily fast and it still is not speech — the signal has no amplitude information.

3

Wind a coil on a soft iron core

Wind several hundred turns of fine enamelled wire onto an iron core. Two of these, identical, are the whole instrument.

此步骤所需材料:

Enamelled Copper WireEnamelled Copper Wire50
4

Fit a permanent magnet behind the core

Mount a magnet against the core so the coil sits in a steady field. Without a bias magnet the output doubles in frequency and the voice is unrecognisable.

此步骤所需材料:

Neodymium MagnetNeodymium Magnet2
5

Cut a thin iron diaphragm

Cut a disc of thin ferrous sheet to sit just clear of the core. It must be thin enough to move with a voice and stiff enough to return.

此步骤所需材料:

Mild Steel SheetMild Steel Sheet1
6

Set the air gap as small as you dare

Under a millimetre, without touching. Sensitivity falls off sharply with gap — this single clearance decides whether the thing works at all.

所需工具:

Measuring RulerMeasuring Ruler
7

Clamp the diaphragm only at its rim

Hold it around the edge so the centre is free to move. Clamped anywhere else it becomes a plate, not a membrane.

8

Build the second unit identically

Make an exact copy. In Bell's design the transmitter and receiver are the SAME device — the effect runs in both directions.

9

Wire the two coils in a single loop

Connect them with two wires and nothing else. No battery, no amplifier — the speaker's voice supplies all the energy.

此步骤所需材料:

Copper WireCopper Wire20
10

Speak loudly into one and listen at the other

Press the second unit to your ear. It is faint and it is unmistakably a voice — this is a magneto telephone and it needs no power source.

11

Understand where the current comes from

The moving iron diaphragm changes the magnetic flux through the coil and induces a voltage — Faraday's law. Your voice is doing the generating.

12

Now build a carbon transmitter and compare

Fill a small chamber with carbon granules behind a diaphragm and pass a battery current through it. Pressure changes resistance, so the battery is modulated instead of the voice generating power.

此步骤所需材料:

CharcoalCharcoal50
13

Measure how much louder the carbon version is

It is dramatically louder, because it is an amplifier — the voice controls battery energy rather than supplying it. Edison's carbon transmitter, not Bell's, is what made telephony practical over distance.

14

Lengthen the line and find the limit

Add wire and re-test. The magneto version fades quickly; the carbon version carries much further. Line loss is why the network needed loading coils and later repeaters.

15

Compendium — an analogue, not a code

The patent. US 174,465, "Improvement in Telegraphy", granted 7 March 1876 to Alexander Graham Bell. Its commercial value was extraordinary and it was litigated more than almost any patent in history — the Bell company fought some six hundred challenges and won essentially all of them. Bell's famous first intelligible sentence to Thomas Watson came three days after the grant, on 10 March 1876.

The priority dispute is real and unresolved. Elisha Gray filed a caveat describing a liquid transmitter at the same patent office on the same day, 14 February 1876. Antonio Meucci had demonstrated voice-over-wire devices in New York from the 1850s but could not afford to maintain a patent caveat; in 2002 the US House of Representatives passed a resolution recognising his contribution. Johann Philipp Reis built a working sound transmitter in Germany in 1861. Bell got the patent and built the industry; the claim that he was the sole originator of the idea does not survive contact with the record, and it is worth stating that plainly rather than smoothing it over.

Two ways to modulate a wire. Bell's magneto instrument is a generator: a moving iron diaphragm alters the flux through a coil and induces a current directly, so the sound energy of the voice IS the signal energy. It needs no battery and it is symmetrical — the same unit works as microphone or earpiece. A carbon transmitter is instead a variable resistor: sound pressure squeezes carbon granules, resistance falls, and a battery current is modulated. That is amplification, and it delivered vastly more signal power to the line. Edison patented the carbon transmitter and it, combined with Bell's receiver, is what the telephone network actually ran on for a century.

Why the bias magnet matters. An iron diaphragm in front of a plain electromagnet is attracted regardless of current direction, so it responds twice per cycle and the output is distorted to double frequency. Adding a permanent magnet biases the system so the varying field adds to or subtracts from a steady one, and the diaphragm follows the waveform linearly. It is the same reason a loudspeaker has a permanent magnet, and the same class of trick as biasing an amplifier — build the signal on top of a steady offset so the response stays linear.

材料

5

所需工具

2

相关蓝图

这些蓝图共享知识——技术、材料或原理

CC0 公共领域

此蓝图以 CC0 协议发布。你可以自由复制、修改、分发和使用此作品,无需征得许可。

通过购买蓝图中的产品支持创客,他们将获得 创客佣金 (由供应商设定),或创建此蓝图的新版本并将其作为连接包含在你自己的蓝图中以分享收入。

讨论

(0)

登录 加入讨论

加载评论中...