Gasholder: Water-Sealed Zinc Gasometer with Balance Weights (Ramsay & Travers, 1898)

The laboratory gasometer Ramsay and Travers used to store argon: a zinc bell that rises and falls in a narrow ring of water between two fixed zinc cylinders. Because the water space is only about 2 cm wide, little gas dissolves in it. Weights on cords over pulleys balance the bell, and weights laid on top push the gas out. Result: a water-sealed gasholder of 18 to 180 litres. Source: M. W. Travers, The Experimental Study of Gases (1901), pp. 30 and 105-106. Unknown: sizes and how the zinc is joined. Picture: Fig. 34, the small mercury form of the same design.

中级

Unknown

说明

Make the fixed cylinders

Make two concentric zinc cylinders on a closed base, leaving a ring-shaped space about 2 cm wide between them for the water. Make the top of the inner cylinder dome-shaped. Bring a gas pipe with a stopcock up through the inner cylinder. Ours: zinc soldered with tin-lead solder. Not given: sizes, how the zinc is joined, the stopcock.

此步骤所需材料：

锌板1 outer and inner cylinders, base

锡铅焊料1 seams

未知阀门1 gas stopcock

所需工具：

铁皮剪

电烙铁

未知成形方法

未知尺寸

Make and hang the bell

Make the gasholder bell of zinc to fit closely over the inner cylinder and down into the water ring, with a dome-shaped top matching the inner cylinder's, so all the gas can be pushed out. Ramsay and Travers made bells of about 180, 27, 18 and 18 litres. Tie a cord to the top of the bell and pass it over pulleys to a hanging weight, to take the bell's own weight off the gas. Fill the ring with water. To deliver gas, take weight off the cord or lay weights on top of the bell. Not given: the weights.

此步骤所需材料：

锌板1 bell

锡铅焊料1 seams