合作
艺术
美容与健康
工艺
文化与历史
娱乐
环境
食品与饮料
逆向工程
科学
体育
技术
可穿戴设备
Nylon Insert Lock Nut: a Nylon Collar Crimped into a Steel Nut
A nut that will not shake loose. A nylon collar sits in a recess at the top of the nut; its hole is a little smaller than the bolt, so the bolt presses its own thread into the nylon and the nylon grips it. Sauer (US 2,450,694, 1948) chose nylon over the older fibre collar: it hardly takes up water and still locks after 50 to 100 re-uses. The collar is held as Swanstrom's patent (US 2,153,681, 1939) shows: the recess wall is pressed in and crimped over it. Size M10 is ours.
The picture: a nylon-insert lock nut (Wikimedia Commons).
中级
Half a day
说明
1
1
Cut and turn the blank
Cut and turn the blank
Saw a blank from hex bar. On the lathe, turn the top part round, with a wall that tapers toward the top.
此步骤所需材料：
低碳钢六角棒1.5 厘米所需工具：
钢锯
金属车床
车床切削刀具
游标卡尺2
2
Drill and tap
Drill and tap
Drill through and tap an M10 thread.
所需工具：
台钻
丝锥板牙套装游标卡尺3
3
Counterbore the top
Counterbore the top
Counterbore the top of the bore with an ordinary twist drill. It leaves a recess with a conical floor.
所需工具：
台钻游标卡尺4
4
Mould the nylon collar
Mould the nylon collar
Mould a nylon washer that fits the recess, with a hole somewhat smaller than the bolt's outside thread diameter. Nylon is thermoplastic, so scrap can be moulded again.
此步骤所需材料：
尼龙颗粒2 克所需工具：
注塑机游标卡尺5
5
Seat and crimp
Seat and crimp
Push the collar down onto the recess floor. In the press, squeeze the recess wall inward against the collar and bend its top edge over it.
所需工具：
台式压力机6
6
Try it on a bolt
Try it on a bolt
Screw the nut onto a bolt. It runs freely until the bolt reaches the collar, then turns stiffly as the bolt cuts a thread in the nylon.
所需工具：
六角头螺栓 - 8.8 级此蓝图制作
CC0 公共领域
此蓝图以 CC0 协议发布。你可以自由复制、修改、分发和使用此作品，无需征得许可。
通过购买蓝图中的产品支持创客，他们将获得 创客佣金 （由供应商设定），或创建此蓝图的新版本并将其作为连接包含在你自己的蓝图中以分享收入。