艺术
美容与健康
工艺
文化与历史
娱乐
环境
食品与饮料
绿色未来
逆向工程
科学
体育
技术
可穿戴设备
Waterproofing a Basket with Pine Pitch — Sealed Container for Liquids
Before pottery, humans needed waterproof containers for storing and transporting water, cooking by hot-stone boiling, and fermenting beverages. One of the oldest solutions was coating a tightly woven basket with pine pitch (or birch tar) to seal the gaps between the weave. Many Indigenous peoples of western North America used pitch-lined baskets as their primary cooking and water-storage vessels for thousands of years. The technique requires a very tightly woven basket (coiled construction works best) and properly prepared pine pitch that is viscous enough to coat but not so hot that it burns the basket fibres. The pitch fills every gap in the weave and, once cooled, creates a rigid, waterproof shell that can hold water indefinitely.
中级
2-3 hours
说明
1
1
Start with a Tightly Woven Basket
Start with a Tightly Woven Basket
Select a tightly woven basket — coiled construction is ideal because the coils pack tightly with minimal gaps. A wicker or twill-woven basket can also work if the weave is very tight. The basket should be the size you need for its intended purpose: water storage, cooking, or carrying.
此步骤所需材料：
Cordage1 个2
2
Inspect the Basket for Gaps
Inspect the Basket for Gaps
Hold the basket up to a light source and look for gaps or pinholes between the weave elements. Any gap visible to the eye will leak. Mark problem areas for extra pitch attention. If the weave has large gaps, the basket is too loosely woven and should be replaced with a tighter one.
3
3
Warm Solid Pine Resin Until It Flows
Warm Solid Pine Resin Until It Flows
Prepare pine pitch by warming solid pine resin gently over low heat until it flows freely. Do not boil the pitch — overheated pitch becomes brittle when it cools and will crack and flake off the basket. The pitch should have the consistency of warm honey, flowing slowly when tilted.
4
4
Mix Pitch with Crushed Charcoal
Mix Pitch with Crushed Charcoal
Stir a small amount of finely crushed charcoal into the warm pitch at a ratio of roughly 4 parts pitch to 1 part charcoal. The charcoal adds flexibility to the dried pitch, preventing it from becoming too brittle. It also darkens the coating, making it easier to see coverage.
此步骤所需材料：
Charcoal1 个5
5
Pour the First Coat Inside the Basket
Pour the First Coat Inside the Basket
Working quickly while the pitch is warm and fluid, pour a small amount into the basket. Tilt and rotate the basket to spread the pitch across the entire inner surface. Gravity will pull the pitch into the lowest points, so keep rotating to maintain even coverage on the walls.
6
6
Spread Pitch into Corners and Seams
Spread Pitch into Corners and Seams
Use a heated smooth stick to push warm pitch into tight corners, along coil seams, and into any gaps identified during inspection. The stick must be warm enough that the pitch does not stick to it and cool prematurely. Reheat the stick in the fire as needed.
7
7
Apply a Second Thin Coat
Apply a Second Thin Coat
Allow the first coat to cool slightly until it is tacky but no longer flowing. Then apply a second thin coat of warm pitch over the first. Multiple thin coats seal far better than one thick coat — a thick coat traps air bubbles and cracks as it cools and contracts.
8
8
Apply a Third Coat for Full Seal
Apply a Third Coat for Full Seal
Apply a third and final thin coat, paying special attention to the bottom of the basket and the rim where the weave terminates. The rim is the most common leak point because the weave ends are cut short and may leave exposed gaps. Build up a slightly thicker bead of pitch along the rim edge.
9
9
Test for Leaks with Water
Test for Leaks with Water
Once the pitch has cooled enough to handle, fill the basket with water and watch for drips. Set the basket on a dry flat stone and wait 5 minutes. Any drip indicates a pinhole in the coating. Mark leak locations and drain the water before patching.
10
10
Seal Any Remaining Leaks
Seal Any Remaining Leaks
Apply a dab of warm pitch to the outside of the basket at each leak point, pressing it into the weave with a warm stick. Retest with water. Repeat until no drips appear after 5 minutes of holding water.
11
11
Cure the Pitch Before Regular Use
Cure the Pitch Before Regular Use
Let the pitch cure for 24 hours in a warm, dry location before putting the basket into regular service. Fresh pitch may impart a resinous taste to stored water — this fades after the first few uses. The pitch coating will last for months of regular use and can be patched with fresh pitch as needed.
已连接蓝图材料
相关蓝图
这些蓝图共享知识——技术、材料或原理
CC0 公共领域
此蓝图以 CC0 协议发布。你可以自由复制、修改、分发和使用此作品，无需征得许可。
通过购买蓝图中的产品支持创客，他们将获得 创客佣金 （由供应商设定），或创建此蓝图的新版本并将其作为连接包含在你自己的蓝图中以分享收入。