艺术
美容与健康
工艺
文化与历史
娱乐
环境
食品与饮料
逆向工程
科学
体育
技术
可穿戴设备
The Plunger-Filled Fountain Pen: A Measured Dose of Ink per Stroke
Emma

创建者

Emma

30. 九月 2026SE
34
0
0
0
0

The Plunger-Filled Fountain Pen: A Measured Dose of Ink per Stroke

Carrying ink meant carrying an inkstand, and early reservoir pens either flooded or ran dry. Walter Hunt of New York received US 4,927, dated 13 January 1847, for a fountain pen that is "the combination of all in one of inkstand, pen, shaft, and pen holder, so arranged as to be convenient for the pocket, and adapted to the common steel pen". A rubber plunger drawn back lets ink fall from the reservoir into a small filling tube; returned suddenly, it "forces the ink in said tube into the barrel of the pen" through a sponge stopper, so each stroke gives the same dose. "It never dries up, nor leaks, and is certain to throw out the requisite quantity of ink". This rung works out the dose and the number of fillings from Hunt's sizes, then builds a fixed-dose filler from a syringe and an acrylic reservoir and weighs its strokes.
中级
About 3 hours

说明

1

Dose and fillings

正在加载 Jupyter 笔记本…
2

The pen that had to be dipped

The embedded blueprint cuts a quill that must be dipped every few words. Hunt carries the ink with the pen and feeds a fixed dose to a common steel nib.
3

Read US 4,927

"The manner of filling and using, is as follows: when the pen is to be filled, the plunger is drawn back by the thumb and finger, hold of the nut D, which allows the ink to fall from the reservoir B, into the filling tube H. The plunger is then suddenly returned, which forces the ink in said tube into the barrel of the pen, through the aperture K, said plunger forming a perfect stopper in said tube which prevents the escape of the ink until another supply for the pen is required." "Felting, or woolen cloth, will probably answer in the room of sponge, for the purpose of the stopper, as its office is to check the flow of the ink through the aperture K, except under the pressure of the piston as before stated."
4

Build the filler and weigh its doses

**Reservoir.** Cut 5 cm of clear acrylic tube as the reservoir and seal a disc of rubber sheet across its lower end with a hole in the middle. **Filling tube and plunger.** Take a Luer syringe: its barrel is the filling tube, its plunger the piston. Cut a side port in the barrel near its top with the craft knife, below where the plunger sits when drawn back, and seal the reservoir's hole over that port with epoxy, so ink falls in when the plunger is drawn back. **Stopper and nib.** Push a plug of sponge into the syringe's nozzle and fit a dip-pen nib against it. **Test.** Fill the reservoir with ink. Draw the plunger back past the port, wait a moment, and push it home once. Weigh the assembly before and after with the kitchen scale; 1 g of ink is about 1 ml. Do ten strokes and compare the spread with a free squeeze of a syringe. Then write with the nib until it runs dry, and count the words.

此步骤所需材料:

亚克力管(透明)亚克力管(透明)0.05 米
注射器 - Luer注射器 - Luer1 个
橡胶板橡胶板1 个
海绵海绵1 个
环氧树脂环氧树脂5 毫升
书写墨水书写墨水30 毫升

所需工具:

钢锯钢锯
手工刀手工刀
充电式电钻充电式电钻
钻头套装钻头套装
数字厨房秤数字厨房秤
书法蘸水笔套装书法蘸水笔套装
5

A filler that floods, runs dry or gives uneven doses

Plunger-filled fountain pen troubleshooting.

Flow

Loading...
6

History and honest limits

**Walter Hunt** of New York signed US 4,927 on 12 September 1845; it is dated 13 January 1847. His plunger was india rubber, or leather saturated with india-rubber paste, on a wire piston rod through a stuffing box; a band with a crescent opening held the pen, and a sliding holder let the pen be drawn back and shielded for the pocket. His claim is the filling tube of graduated capacity combined with the fountain pen. The same Walter Hunt patented the float inkstand in 1845 and later the safety pin. **Honest limits.** A Luer syringe and an acrylic tube stand in for his shaft, reservoir and plunger. The notebook uses his printed sizes, taking the bulb as a cylinder. Your dose weighings are the result.

材料

6

所需工具

6

此蓝图制作

CC0 公共领域

此蓝图以 CC0 协议发布。你可以自由复制、修改、分发和使用此作品,无需征得许可。

通过购买蓝图中的产品支持创客,他们将获得 创客佣金 (由供应商设定),或创建此蓝图的新版本并将其作为连接包含在你自己的蓝图中以分享收入。

讨论

(0)

登录 加入讨论

加载评论中...