Veneer Hammer: an Iron Strip Set in a Wooden Head (Work, 1889)

The veneering hammer does not strike: it is drawn over glued veneer like a squeegee, pressing it down. David Adamson (1889) says it is hardly worth buying, as anyone can make one: a strip of iron 3 to 6 inches long set in a wooden head with a handle, its edge projecting, straight, and smoothly rounded. Shape and size do not matter much; it must be strong, the iron thick enough not to bend, and the edge smooth. Source: D. Adamson, 'Practical Veneering', Work, 5 October 1889, p. 453. Picture: his Fig. 1.

初学者

Unknown

说明

Read Adamson

"A strip of iron of, say, from 3 in. to 6 in. long and of any convenient width is firmly fixed between two pieces of wood, or in a groove cut in one piece to form the head. In this a handle is inserted. The precise shape and size of any part are quite immaterial, the principal points to be observed being strength and convenience."

Cut the iron strip

Cut a strip of iron 3 to 6 in. long and of any convenient width, thick enough not to bend when the hammer is pressed hard. Its thickness is not given (unknown). Ours: cut from iron plate with a hacksaw.

此步骤所需材料：

铁板1 strip 3-6 in.

所需工具：

钢锯

未知尺寸

Make the head

Cut a groove in a block of wood and fix the strip firmly in it, with its edge projecting beyond the wood (or fix it between two pieces of wood). Fit a handle into the head. The wood, and how the strip and handle are fixed, are not given (unknown). Ours: a hardwood block, the groove sawn.

此步骤所需材料：

硬木块1 head

工具柄1 个

未知连接器1 个

所需工具：

夹背锯

Round the edge

File the projecting iron edge straight, smooth and rounded so it passes freely over the veneer, and slightly round off its lower corners so they do not damage the veneer. The smoother the edge, the easier the tool is to use.

所需工具：