KUNST
SCHÖNHEIT & WELLNESS
HANDWERK
KULTUR & GESCHICHTE
UNTERHALTUNG
UMFELD
ESSEN & GETRÄNKE
GRÜNE ZUKUNFT
REVERSE ENGINEERING
School Projects
WISSENSCHAFTEN
SPORT
TECHNOLOGIE
WEARABLES
Building an Erhu — The Chinese Two-String Bowed Fiddle
Woody

Erstellt von

Woody

3. Juli 2026NO
0
0
0
0
0

Building an Erhu — The Chinese Two-String Bowed Fiddle

Build an erhu: a two-string Chinese fiddle with a bow trapped between the strings, a little skin-covered drum for a body, and no fingerboard — you press the strings in mid-air and slide between notes. A serious maker build in the bowed string and stick-slip friction, the physics behind every violin.
Fortgeschritten
Several hours over a few sessions

Anweisungen

1

A fiddle with a drum for a body

The erhu has just two strings, a bow that lives trapped between them, and a little skin-covered drum for a body. It has no fingerboard, so you press the strings in mid-air and slide to every note between.
2

Make the resonator drum

Cut a short, thick length of bamboo about 13 cm long, open at both ends. This little hollow tube is the sound-body of the erhu.

Materialien für diesen Schritt:

BambooBamboo1 Stück

Benötigte Werkzeuge:

HacksawHacksaw
3

Skin the front

Soak a piece of rawhide, stretch it drum-tight over one end of the tube, glue and lash it down, and let it dry hard. This membrane is what makes the erhu loud, like a banjo head.

Materialien für diesen Schritt:

RawhideRawhide1 Stück
PVA Wood GluePVA Wood Glue1 Stück
4

Fit the neck

Push a long dowel neck down through the body near the skin end, so it stands up tall and straight from the drum.

Materialien für diesen Schritt:

Dowel RodDowel Rod1 Stück
PVA Wood GluePVA Wood Glue1 Stück
5

Fit two tuning pegs

Bore two holes near the top of the neck and fit a friction tuning peg into each, one above the other.

Materialien für diesen Schritt:

Tuning PegsTuning Pegs2 Stück

Benötigte Werkzeuge:

AwlAwl
6

String it

Run two strings from the base of the body up to the two pegs, close together and parallel — the erhu's whole set of strings.

Materialien für diesen Schritt:

Steel Music Wire 0.032"Steel Music Wire 0.032"1 Stück
7

Stand the bridge on the skin

Carve a tiny wooden bridge and stand it on the middle of the skin, under the strings, so the strings press down onto the membrane.

Benötigte Werkzeuge:

Sloyd Carving KnifeSloyd Carving Knife
8

Tune the two strings a fifth apart

Tune the inner string to a low note and the outer string a fifth higher, like D and A. Twist the pegs to reach the two notes.
9

Make the bow

Tie a flat hank of horsehair between the two ends of a springy stick to make a bow, tight enough to twang.

Materialien für diesen Schritt:

Curved Branch (Bow)Curved Branch (Bow)1 Stück
Bow Hair (Horsehair)Bow Hair (Horsehair)1 Stück
10

Thread the bow between the strings

Slide the bow hair BETWEEN the two strings. On an erhu the bow lives there permanently and cannot be taken out — that is why it plays only its own two strings.
11

Rosin the hair

Rub hard pine rosin along the bow hair so it grips the strings. Without rosin the hair is too slippery to set a string singing.
12

Play a note

Draw the bow steadily across a string. Press the hair toward the inner or the outer string to choose which one sounds.
13

Slide and bend

With no fingerboard, press a string in open air and slide your finger up or down the neck to glide smoothly between notes — the erhu's crying, singing voice.
14

Compendium — bowing and the skin drum

The erhu makes sound the way every bowed instrument does: by stick-slip friction. The rosined hair grabs the string and drags it sideways until the string's tension tears it free; the string snaps back, is caught again, and the cycle repeats hundreds of times a second. This catch-and-release, called Helmholtz motion, keeps the string vibrating steadily for as long as you bow — which is why a bowed note can sing on and on while a plucked one quickly dies. Unlike a lyre or a guitar, the erhu's soundbox is a little DRUM: the strings press through the bridge onto a stretched skin, and that membrane radiates the sound into the air, exactly as a banjo head does, giving the erhu its bright, nasal, almost human voice. And it has no fingerboard — you stop the strings by pressing them in open air — so there are no fixed frets and you can slide through every pitch, which is why the erhu can weep and sing like a person. It grew from the bowed huqin fiddles of the Tang and Song dynasties more than a thousand years ago, and its two strings are tuned a fifth apart. Its cousins are the whole huqin family and, far to the west, every member of the violin family — all of them stick-slip machines singing through a resonating body.

Materialien

8

Benötigte Werkzeuge

3

You can swap these in

Can't get one of the materials? Swap it for an equivalent — these work just as well.

Verwandte Blueprints

Diese Blueprints teilen Wissen — Techniken, Materialien oder Prinzipien

CC0 Gemeinfrei

Dieser Blueprint ist unter CC0 veröffentlicht. Sie dürfen dieses Werk für jeden Zweck frei kopieren, ändern, verbreiten und verwenden, ohne um Erlaubnis zu fragen.

Unterstützen Sie den Maker, indem Sie Produkte über seinen Blueprint kaufen, wo er eine Maker-Provision von Anbietern festgelegt, verdient. Oder erstellen Sie eine neue Iteration dieses Blueprints und verbinden Sie ihn in Ihrem eigenen Blueprint, um Einnahmen zu teilen.

Diskussion

(0)

Anmelden um an der Diskussion teilzunehmen

Kommentare werden geladen...