Colaboración
ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE
Clamping Caul: Plain Pine Board Shaped to the Work (Adamson, 1889)
A caul is a board laid over glued work so the clamps press evenly over the whole surface instead of only under their jaws. D. Adamson (1889) uses a piece of good sound pine about 1 in. thick, shaped exactly to fit the surface: flat for a flat panel, convex for a concave one.
For veneering he warms it first. Wood can warp or twist, and burns if overheated; a zinc-faced caul (separate blueprint) lasts longer.
Source: D. Adamson, "Practical Veneering", Work, 5 October 1889, pp. 453-455.
Principiante
Unknown
Instrucciones
1
1
Read Adamson
Read Adamson
"The caul itself is either wood or metal, either of which must be shaped exactly to fit the surface to be veneered. Thus for a flat panel it must be flat, while for a concave surface it must be convex, and so on. ... For the material nothing is more suitable than good sound pine."
2
2
Cut the board
Cut the board
Cut a piece of good sound pine about 1 in. thick, large enough to cover the whole surface to be pressed. Thicker is no better, only waste. The length and width are set by the work (not given).
Materiales para este paso:
Tabla de pino1 about 1 in. thickHerramientas necesarias:
Serrucho de carpintero
Dimensiones desconocidas3
3
Shape it to the work
Shape it to the work
Plane the face that meets the work to fit it exactly: flat for a flat panel, convex for a concave surface. A caul that is hollow in the middle presses only at the edges. How it is trued is not given (ours: plane, checked with a straightedge).
Herramientas necesarias:
Cepillo de carpintero
Regla de trazar4
4
Use it
Use it
Warm the caul (not so hot that it cannot be comfortably handled), lay it over the veneer with a sheet of slightly greased paper between, and screw down the hand-screws evenly until the glue oozes out at the edges. Leave it until the caul is cold, an hour or two.
Herramientas necesarias:
SargentosMateriales
1- 1 about 1 in. thickMarcador de posición
Herramientas requeridas
5- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
Este plano hace
CC0 Dominio público
Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.
Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.