Colaboración
ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE

Half-Round Taper Reamer: Tool Steel Turned to the Taper, Filed Flat to the Centre Line, Hardened (Griswold, Amateur Work, 1905)
The simplest home-made taper reamer, from Robert Gibson Griswold's Tool Making for Amateurs (Boston, 1905): tool steel turned to the taper wanted (his was 1/8 in. per foot), one side filed away exactly to the centre line so that two cutting edges remain, then hardened and ground on the flat face only. It reams a very smooth conical hole.
Intermedio
Two to three hours
Instrucciones
1
1
His taper
His taper
Cargando el cuaderno de Jupyter…
2
2
Read Griswold
Read Griswold
"Turn a piece of tool steel to the proper taper and then file away one side until the flat surface coincides with the center line."
3
3
Turn the taper
Turn the taper
Turn a piece of tool steel in the lathe to the taper of the part the hole must fit (his: 1/8 in. per foot). Length and diameter are ours: a little longer than the hole and spanning its two diameters.
Materiales para este paso:
Barra de acero de herramientas1 piezaHerramientas necesarias:
Torno de metal
Calibre4
4
File to the centre line
File to the centre line
Hold it in the vice and file away one side until the flat face lies exactly on the centre line. This leaves a cutting edge on each side.
Herramientas necesarias:
Tornillo de banco
Limas (lima de mano)
Calibre5
5
Harden and grind
Harden and grind
Harden it (ours: heat to a cherry red and quench in water, temper to a straw colour), then grind on the flat side only, never on the round.
Herramientas necesarias:
Fragua de herrero
Cubo de temple
Esmeril de banco6
6
Troubleshooting
Troubleshooting
Reamer troubleshooting.
Flow
Loading...
7
7
History and honest limits
History and honest limits
From Robert Gibson Griswold, "Tool Making for Amateurs" VII, **Amateur Work** (Boston), vol. IV (1904-05), p. 128 (checked on the archive.org scan amateurwork04bostrich). He gives no size or temper for the reamer; those and the tools are ours. He finishes the hardened bushings with a copper lap and emery.
Materiales
1- Marcador de posición
Herramientas requeridas
7- Marcador de posición
- 1 vendor sell this, none ship to you yetMarcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
Este plano hace
Blueprints relacionados
Estos blueprints comparten conocimiento — técnicas, materiales o principios
CC0 Dominio público
Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.
Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.

