ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE
Plain-Weave Cotton Cloth on a Rigid Heddle Loom
Plain weave is the simplest cloth: each crosswise thread goes over one lengthwise thread and under the next, and back the other way on the next pass. A rigid heddle loom does the lifting: one bar of slots and holes raises or lowers every other warp thread at once.
The thread is the 2-ply cotton from the hand-spinning blueprint, used for both warp and weft.
Intermedio
About a week of evenings
Instrucciones
1
1
The thread
The thread
Spinning and plying the cotton thread used here.
2
2
Find the sett
Find the sett
Wrap the thread round a ruler, touching but not crowded, and count the wraps in 2.5 cm. For plain weave set the warp at about half that many threads per 2.5 cm, and choose the heddle to match.
Herramientas necesarias:
Regla3
3
Measure the warp
Measure the warp
On the warping board wind as many threads as the width times the sett, each the cloth's length plus about 50 cm for tying on and loom waste.
Materiales para este paso:
Hilo de algodón150 gHerramientas necesarias:
Urdidera de pared
Cinta métrica4
4
Thread the heddle
Thread the heddle
Thread one warp end through each slot and each hole in turn, tie the ends to the back beam, wind on under even tension and tie on at the front.
Herramientas necesarias:
Telar de peine rígido5
5
Weave
Weave
Raise the heddle, pass the shuttle through, beat the weft gently with the heddle; lower the heddle, pass back, beat. Leave the weft at a slant across the shed so the edges do not pull in.
Materiales para este paso:
Hilo de algodón120 gHerramientas necesarias:
Telar de peine rígido
Lanzadera6
6
Cut off and secure
Cut off and secure
Cut the cloth off the loom and knot or hem both ends so the weft cannot slip off.
Herramientas necesarias:
Tijeras de sastre7
7
Wash to finish
Wash to finish
Wash the cloth in hot water, dry it, and measure it: the threads relax and close up. Note how much it shrank for the next warp.
Herramientas necesarias:
Cinta métrica8
8
Troubleshooting
Troubleshooting
Plain weave troubleshooting.
Flow
Loading...
Materiales
1- 270 gMarcador de posición
Este plano hace
Blueprints relacionados
Estos blueprints comparten conocimiento — técnicas, materiales o principios
CC0 Dominio público
Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.
Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.