Colaboración
ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE
Ring Stand: a Brass Rod on a Board Foot with Sliding Rings (Faraday, 1830)
A stand that holds flasks and basins at any height over a lamp or furnace. Michael Faraday (1830) describes the retort-stand: an upright brass rod on a heavy foot, with rings of several sizes, each on an arm whose socket slides up and down the rod and is fixed by a screw-nut at the back.
Brass feet filled with lead tip over under a heavy vessel, so he makes the foot a stout board about 12 x 6 x 1 inches, the rod fixed 1 1/2 inches from one end, and stands the lamp or furnace on the board under the ring.
Source: M. Faraday, Chemical Manipulation (1830), §386, p. 175. Picture: his woodcut.
Principiante
Unknown
Instrucciones
1
1
Read Faraday
Read Faraday
"It is much better to make the foot of a piece of stout board, about twelve inches in length, six inches in width, and an inch thick. The upright rod should be fixed about one inch and a half from one end of it, the lamp or furnace should be placed upon it, and the ring of course in a corresponding direction. Such an arrangement is perfectly steady, and cannot be overset by any weight which it is strong enough to bear."
2
2
Fix the rod in the board
Fix the rod in the board
Take a stout board about 12 in. long, 6 in. wide and 1 in. thick. Fix an upright brass rod in it about 1 1/2 in. from one end. Rod size, and how it is fixed, are not given (unknown). Ours: a hardwood board.
Materiales para este paso:
Tabla de madera dura1 pies
Barra de latón1 upright
Conector desconocido1 piezaHerramientas necesarias:
Dimensiones desconocidas3
3
Make the rings
Make the rings
Make several rings of different sizes, each fixed to an arm, and each arm to a socket that slides freely up and down the rod. Fit each socket with a screw-nut at the back to tighten it at any height. The metal and sizes are not given (unknown). Ours: wing nuts for the screw-nuts.
Materiales para este paso:
Metal desconocido1 rings, arms, sockets
Tuerca mariposa1 piezaHerramientas necesarias:
Dimensiones desconocidas4
4
Use it
Use it
Stand the lamp or furnace on the board and turn the ring over it. Slide the ring to the height wanted and tighten the screw. Do not set a hot flask on a cold ring, or a cold, freshly filled flask on a hot ring over the fire: the bottom may come out (Faraday §388).
Materiales
5- 1 piesMarcador de posición
- 1 uprightMarcador de posición
- 1 piezaMarcador de posición
- 1 rings, arms, socketsMarcador de posición
- 1 piezaMarcador de posición
Herramientas requeridas
1- Marcador de posición
Este plano hace
CC0 Dominio público
Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.
Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.