ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE

Riven Hardwood Handle Stock
Tool handles take shock along their length, so handle makers split them from straight logs of tough woods such as ash and hickory: a split follows the grain, and a handle whose fibres run end to end does not snap where sawn grain runs out. Rive the blanks green, shave them roughly to size, and let them dry before final shaping.
Principiante
Half a day, plus months drying
Instrucciones
1
1
Cut a billet
Cut a billet
Saw a straight, knot-free ash or hickory log to the handle length plus 5 cm.
Materiales para este paso:
Troncos de madera dura (roble, arce, haya)1 piezaHerramientas necesarias:
Tronzador
Cinta métrica2
2
Split it
Split it
Split the billet in half with the splitting axe, then into quarters and eighths with the froe and mallet, until each blank is a little larger than the handle.
Herramientas necesarias:
Hacha de partir
Hendidor (froe)
Mazo de madera
Gafas de seguridad3
3
Shave to rough size
Shave to rough size
Clamp each blank in the shaving horse and remove the bark and the pith edge with the drawknife, following the grain.
Herramientas necesarias:
Banco de doladura
Cuchilla de dos mangos4
4
Seal and dry
Seal and dry
Seal the ends and dry the blanks indoors, spaced apart, until the moisture meter reads close to the room's level.
Materiales para este paso:
Sellador de testas (parafina)0.1 litroHerramientas necesarias:
Medidor de humedad5
5
Final shaping
Final shaping
When dry, true the blanks with the spokeshave and store them ready for handles.
Herramientas necesarias:
Cuchilla de dos manos
Banco de doladuraMateriales
2- Marcador de posición
- 0.1 litroMarcador de posición
Herramientas requeridas
10- Marcador de posición
- 1 vendor sell this, none ship to you yetMarcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
- Marcador de posición
Este plano hace
Blueprints relacionados
Estos blueprints comparten conocimiento — técnicas, materiales o principios
CC0 Dominio público
Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.
Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.






