Kolaborasi
SENI
KECANTIKAN & KESEHATAN
KERAJINAN
BUDAYA & SEJARAH
HIBURAN
LINGKUNGAN
MAKANAN & MINUMAN
REKAYASA BALIK
ILMU PENGETAHUAN
OLAHRAGA
TEKNOLOGI
PERANGKAT PAKAI
Trick Lariat That Will Not Twist: Brass Swivels in the Rope and a Choker on the Hondoo (La Rue, 1935)
Tex

Dibuat oleh

Tex

13. November 2026FO
10
0
0
0
0

Trick Lariat That Will Not Twist: Brass Swivels in the Rope and a Choker on the Hondoo (La Rue, 1935)

Richard L. La Rue of Los Angeles received US 1,993,010, dated 5 March 1935, for a lariat that beginners can spin. A spinning loop twists the rope; an expert lets it roll in the hand, a beginner cannot. La Rue cuts the rope into sections joined by small brass swivels, so the twist runs out. The hondoo, the eye the rope runs through, is clamped in a brass ferrule, and a wire choker can lock the loop at one size. We make it from cotton rope and brass tube. All sizes are ours.
Menengah
About 4 hours

Instruksi

1

Where the swivels go

Memuat notebook Jupyter…
2

Read US 1,993,010

"In accordance with the present invention, twisting of the rope is prevented by inserting several swivels at intervals along the rope, so that no matter how the operator holds it there is always at least one swivel between his hand and the loop. The swivels are made substantially the same outside diameter as the rope so that they pass readily through the hondoo."
3

Cut the rope

Cut 6 m of 10 mm braided cotton rope (ours) into the sections the notebook gives. Wrap tape round each place before cutting so the ends do not fray.

Material untuk langkah ini:

Tambang kapasTambang kapas1 buah

Alat yang dibutuhkan:

Meteran GulungMeteran Gulung
Pisau KerajinanPisau Kerajinan
4

Make the ferrules

For three swivels cut six 25 mm pieces of 3/8 in brass tube (ours), his ferrules 6, and file the ends square. Soften the brass by heating each piece to a dull red with the torch and dropping it in water. On the anvil, tap one end of each inward all round with the hammer, turning it as you go, until the opening is about 4.5 mm: his end wall 7. Flare the other end out a little so the rope will go in.

Material untuk langkah ini:

Pipa kuningan diameter luar 9,5 mmPipa kuningan diameter luar 9,5 mm1 buah

Alat yang dibutuhkan:

Gergaji BesiGergaji Besi
Set KikirSet Kikir
Obor PropanaObor Propana
Ember pendingin tempaEmber pendingin tempa
AirAir
Landasan TempaLandasan Tempa
Palu kepala bulatPalu kepala bulat
Kacamata pengamanKacamata pengaman
5

Join the ferrules into swivels

Cut three 10 mm pieces of 4 mm brass tube (ours), his member 8. Put two ferrules end wall to end wall, push the small tube through both openings, and flare its ends with a centre punch from inside each ferrule until they cannot pull back through: his flanges 9. The two halves must turn freely on each other.

Material untuk langkah ini:

Tabung kuninganTabung kuningan1 buah

Alat yang dibutuhkan:

Gergaji BesiGergaji Besi
PenitikPenitik
Palu kepala bulatPalu kepala bulat
Ragum MejaRagum Meja
6

Fit the rope into the swivels

Push a rope end into each open ferrule as far as it goes. Squeeze the flared end back in, with the hammer on the anvil or in the vice, until it digs into the rope all round. Pull hard on each joint to test it.

Alat yang dibutuhkan:

Palu kepala bulatPalu kepala bulat
Landasan TempaLandasan Tempa
Ragum MejaRagum Meja
7

Make the hondoo

Cut 40 mm of brass tube big enough to take the rope doubled (ours) and saw it open along its length. Squeeze one end round the single rope; flatten the other end into an oval. Pass the loop end of the rope through, from the small end, then double its butt end back and push it into the oval end as far as it will go, leaving a small eye: his hondoo 3. Dent the oval end to hold the butt (his 14) and turn one cut edge in against the rope (his 15).

Material untuk langkah ini:

Tabung kuninganTabung kuningan1 buah

Alat yang dibutuhkan:

Gergaji BesiGergaji Besi
Ragum MejaRagum Meja
Tang Berujung RataTang Berujung Rata
PenitikPenitik
Palu kepala bulatPalu kepala bulat
8

Bend the choker

Bend 2.5 mm steel wire (ours) into a figure 8 round the two rope parts of the hondoo, one eye on each, so it slides when pushed but stays put by friction. Pass the free end of the rope through the hondoo to make the loop.

Material untuk langkah ini:

Kawat bajaKawat baja1 buah

Alat yang dibutuhkan:

Tang potongTang potong
Tang berujung bulatTang berujung bulat
Tang Berujung RataTang Berujung Rata
9

Use it

With the choker pushed up to the ferrule, the rope runs freely through the hondoo like any lariat. To spin a loop of one size, slide the choker away from the ferrule until the hondoo grips the running rope: the loop then stays the same size while it spins.
10

Troubleshooting

Swivel trick lariat troubleshooting.

Flow

Loading...
11

History and honest limits

**Richard L. La Rue** of Los Angeles, US 1,993,010, dated 5 March 1935, filed 16 November 1932, for "a lariat for use by amateurs in performing tricks". He claimed the choker, "a figure 8 clamp of heavy wire", and a clamp "movable back and forth over the doubled rope constituting the hondoo for varying the size of the eye". He also shows a second choker of bent wire (Fig. 6), not built here. He names no rope and gives no sizes: the cotton rope, its length, the tubes, the annealing, the wire and all sizes are ours.

Bahan

4

Alat yang Diperlukan

15

Cetak biru ini membuat

Blueprint terkait

Blueprint ini berbagi pengetahuan — teknik, bahan, atau prinsip

CC0 Domain Publik

Cetak biru ini dirilis di bawah CC0. Anda bebas untuk menyalin, memodifikasi, mendistribusikan, dan menggunakan karya ini untuk tujuan apa pun, termasuk komersial, tanpa meminta izin.

Dukung Maker dengan membeli produk melalui Cetak Biru mereka di mana mereka mendapatkan Komisi Pembuat yang ditetapkan oleh Penjual, atau buat iterasi baru dari Cetak Biru ini dan masukkan sebagai koneksi di milik Anda sendiri.

Diskusi

(0)

Masuk untuk bergabung dengan diskusi

Memuat komentar...