Kolaborasi
SENI
KECANTIKAN & KESEHATAN
KERAJINAN
BUDAYA & SEJARAH
HIBURAN
LINGKUNGAN
MAKANAN & MINUMAN
REKAYASA BALIK
ILMU PENGETAHUAN
OLAHRAGA
TEKNOLOGI
PERANGKAT PAKAI

Lead Came Mould: Two Hinged Grooved Irons (Theophilus, tr. Hendrie 1847)
The iron mould in which Theophilus cast the lead rods of glass windows: two irons a yard long, hinged at one end with a nail, filed to close without a chink of light, with a matching groove hollowed down the middle of each so the lead poured in makes one rod.
The free ends are made a little wider and thinner to form a pouring mouth, and the two halves are keyed so they cannot slip while casting.
Source: Theophilus, De Diversis Artibus, Book II, ch. XXIV, tr. R. Hendrie (1847), p. 147. Picture: the chapter.
Menengah
Unknown
Instruksi
1
1
Hinge the irons
Hinge the irons
Take two irons two fingers broad, one finger thick and a yard long. Join them at one end like a hinge, fastened by a nail, so they open and shut. Make the other ends a little wider and thinner, so that when shut they form the start of a cavity (the pouring mouth). Not given: how the hinge is formed.
Material untuk langkah ini:
Batang besi tempa2 2 fingers x 1 finger x 1 yard
Paku1 hinge pinAlat yang dibutuhkan:
Palu2
2
Fit the faces
Fit the faces
Let the outer sides lie even, and file the two faces together until no light shows between them when closed.
Alat yang dibutuhkan:
Kikir Logam3
3
Cut the grooves
Cut the grooves
Open the irons. With a rule, draw two narrow lines down the middle of each piece, facing each other, from top to bottom. Hollow out between them with the chasing iron used for hollowing lamps, as deep as you wish, and rasp a little inside so the lead poured in makes one piece. Key the mouth so one half cannot slip on the other while casting.
Alat yang dibutuhkan:
Penggaris
Kikir kasarCetak biru ini membuat
CC0 Domain Publik
Cetak biru ini dirilis di bawah CC0. Anda bebas untuk menyalin, memodifikasi, mendistribusikan, dan menggunakan karya ini untuk tujuan apa pun, termasuk komersial, tanpa meminta izin.
Dukung Maker dengan membeli produk melalui Cetak Biru mereka di mana mereka mendapatkan Komisi Pembuat yang ditetapkan oleh Penjual, atau buat iterasi baru dari Cetak Biru ini dan masukkan sebagai koneksi di milik Anda sendiri.
