SENI
KECANTIKAN & KESEHATAN
KERAJINAN
BUDAYA & SEJARAH
HIBURAN
LINGKUNGAN
MAKANAN & MINUMAN
REKAYASA BALIK
ILMU PENGETAHUAN
OLAHRAGA
TEKNOLOGI
PERANGKAT PAKAI
Binding a Besom Broom — The Birch-Twig Broom on a Hazel Handle
The besom is the oldest broom: a fat bundle of springy birch twigs bound around a hazel or ash handle. Every household swept with one, and it cost nothing but a walk to the woods. There are no nails and no glue — the head is held by tight withy bindings and a single wooden peg, and it only grips harder as the birch dries and shrinks. This blueprint binds a besom from cut brush to finished broom using hand tools alone.
Pemula
3
Instruksi
1
1
Cut the birch brush
Cut the birch brush
Cut generous bundles of thin, whippy birch twigs — the 'brush'. Winter-cut birch, taken when the tree is bare, is springiest and lasts longest. Keep the twigs long and unbroken.
Material untuk langkah ini:
Birch Brush1 ikatTools needed:
Billhook2
2
Wilt the twigs supple
Wilt the twigs supple
Lay the cut brush somewhere cool for a few days until the twigs lose their brittleness and bend without snapping. Supple twigs pack tightly and bind without cracking.
Material untuk langkah ini:
Birch Brush1 ikat3
3
Cut and point the handle
Cut and point the handle
Cut a straight length of hazel or ash about a thumb-and-a-half thick for the handle. Trim it clean and whittle one end to a long blunt point so the brush seats around it.
Material untuk langkah ini:
Green Wood Poles (1-2m)1 buahTools needed:
Billhook
Knife4
4
Soak the binding withies
Soak the binding withies
Soak split willow withies in water until they are fully flexible. These flexible ties will cinch the brush to the handle; they must bend sharply without breaking.
Material untuk langkah ini:
Willow Withy2 buah
Water5 liter5
5
Lay the brush around the handle
Lay the brush around the handle
Stand the pointed handle upright and lay birch twigs evenly all the way around it, butt ends up along the handle and tips hanging down. Keep the bundle even so the finished broom is not lopsided.
Material untuk langkah ini:
Birch Brush1 ikat6
6
Bind the top band
Bind the top band
Squeeze the twigs tight against the handle and wind a soaked withy hard around the bundle near the top of the brush. Pull it as tight as you can and twist and tuck the ends to lock the band.
Material untuk langkah ini:
Willow Withy1 buah7
7
Bind the second band
Bind the second band
Wind a second withy band about a hand's width below the first and cinch it just as tight. Two bands stop the brush from splaying and spread the sweeping wear.
Material untuk langkah ini:
Willow Withy1 buah8
8
Peg the head to the handle
Peg the head to the handle
Whittle a small hardwood peg. Start a hole through the handle between the bindings with the awl, then drive the peg through with the mallet so the head can never slide off the handle.
Tools needed:
Knife
Awl
Wooden Mallet9
9
Trim the sweeping end
Trim the sweeping end
Trim the hanging tips of the brush level across the bottom with the billhook so the broom meets the floor evenly and sweeps cleanly.
Tools needed:
Billhook10
10
Season the besom
Season the besom
Stand the finished besom in a dry place to season. As the birch dries it stiffens into a firm brush and the withy bindings shrink even tighter — the broom is ready to sweep.
Bahan
4- 3 ikatPlaceholder
- 1 buahPlaceholder
- 4 buahPlaceholder
Connected Blueprint Materials
Blueprint terkait
Blueprint ini berbagi pengetahuan — teknik, bahan, atau prinsip
CC0 Domain Publik
Cetak biru ini dirilis di bawah CC0. Anda bebas untuk menyalin, memodifikasi, mendistribusikan, dan menggunakan karya ini untuk tujuan apa pun, termasuk komersial, tanpa meminta izin.
Dukung Maker dengan membeli produk melalui Cetak Biru mereka di mana mereka mendapatkan Komisi Pembuat yang ditetapkan oleh Penjual, atau buat iterasi baru dari Cetak Biru ini dan masukkan sebagai koneksi di milik Anda sendiri.