SENI
KECANTIKAN & KESEHATAN
KERAJINAN
BUDAYA & SEJARAH
HIBURAN
LINGKUNGAN
MAKANAN & MINUMAN
REKAYASA BALIK
ILMU PENGETAHUAN
OLAHRAGA
TEKNOLOGI
PERANGKAT PAKAI
Reverse Osmosis: Pushing Water Uphill Through a Membrane
Mary

Dibuat oleh

Mary

23. September 2026FI
20
0
0
0
0

Reverse Osmosis: Pushing Water Uphill Through a Membrane

The solar still and the alembic both separate salt from water by evaporating the water — and both pay the latent heat of vaporisation to do it, about 2,400 kilojoules for every kilogram. That energy bill is why distillation stayed expensive for three thousand years. Reverse osmosis does the same separation without a phase change. Osmosis drives fresh water INTO brine through a membrane that passes water and rejects salt; push back harder than that osmotic pressure and the flow reverses, leaving the salt behind. The idea was old, but it was useless until Sidney Loeb and Srinivasa Sourirajan at UCLA made a cellulose acetate film in 1959 with a dense skin a fraction of a micrometre thick on a porous backing — thin enough to pass useful water, sound enough to hold back the salt (US 3,133,132). Every desalination plant since descends from that film.
Lanjutan
1 day

Instruksi

1

Understand what you are pushing against

Osmotic pressure is not friction and it is not the membrane resisting you. It is the pressure the salt solution would pull water in with, and you must exceed it before a single drop crosses the other way. For sea water at 35 grams per litre that is about 27 bar. For the brackish water most small systems treat, a few bar. This one number decides whether your build is a bicycle pump or an industrial plant, and the notebook later works it out for your own water.

Material untuk langkah ini:

GaramGaram35 g

Alat yang dibutuhkan:

Timbangan DigitalTimbangan Digital
Gelas ukur silinderGelas ukur silinder
2

Get a membrane and treat it gently

Use a small domestic RO element — the kind sold for under-sink filters. Note which way round it runs: feed in, permeate out of the centre tube, concentrate out of the far end. Two things kill a membrane quickly. Chlorine destroys polyamide film in hours, so anything chlorinated must go through carbon first — and note the irony, because the previous rung in this batch was about deliberately adding chlorine. And letting it dry out permanently collapses the pore structure: a membrane that has dried never recovers its flux.

Material untuk langkah ini:

Membran osmosis balikMembran osmosis balik1 buah
3

Build the pressure side

Plumb a feed vessel to the membrane through a pump with a gauge in the line, and lead two outlets away: permeate to one jar, concentrate to another through a restrictor. You need BOTH outlets flowing. A membrane run with the concentrate closed off becomes a dead end where salt piles up against the film — concentration polarisation — and the local osmotic pressure climbs until flow stops and scale forms. Every RO system in the world throws away a stream of concentrate; that is not waste, it is what carries the rejected salt out.

Material untuk langkah ini:

Selang SilikonSelang Silikon3 metre

Alat yang dibutuhkan:

Pompa lantai sepedaPompa lantai sepeda
Pengukur TekananPengukur Tekanan
4

Make brackish water and run it

Dissolve 2 grams of salt per litre — brackish, not sea — and run it through at increasing pressure while you watch the permeate outlet. Below the osmotic pressure, nothing comes out. Cross it and permeate starts, slowly at first and then rising roughly in step with how far past it you push. Seeing that threshold with your own gauge is the whole point of building this: it is the moment an abstract equation becomes a thing you did with a pump.

Material untuk langkah ini:

GaramGaram20 g
Air SulingAir Suling10 liter

Alat yang dibutuhkan:

Pengukur TekananPengukur Tekanan
Gelas ukur silinderGelas ukur silinder
StopwatchStopwatch
5

Rejection, flux and the energy bill

Memuat notebook Jupyter…

Alat yang dibutuhkan:

Gelas ukur silinderGelas ukur silinder
StopwatchStopwatch
6

Taste, test, and notice what is missing

Compare feed, permeate and concentrate. The permeate should read near neutral and taste flat; the concentrate should be noticeably saltier than what you started with, because the salt has to go somewhere. RO strips almost everything — salts, metals, most organics, and microbes, which are enormous compared to the pores. That completeness is also the criticism: it removes the calcium and magnesium the body uses, which is why large plants remineralise afterwards rather than delivering the pure product.

Alat yang dibutuhkan:

Kertas uji pHKertas uji pH
Stoples KacaStoples Kaca
7

Flush it, and never let it dry

Flush with clean water at low pressure for a few minutes after every run, to wash the concentrated layer off the film before it can crystallise. For storage, keep the element wet and cool. If you will not use it for weeks, store it in the preservative solution it came in. A dried-out membrane looks identical to a working one, and behaves like a blank sheet of plastic — the most expensive way there is to learn this lesson.

Material untuk langkah ini:

Air SulingAir Suling5 liter

Alat yang dibutuhkan:

Pompa lantai sepedaPompa lantai sepeda

Bahan

4

Alat yang Diperlukan

7

CC0 Domain Publik

Cetak biru ini dirilis di bawah CC0. Anda bebas untuk menyalin, memodifikasi, mendistribusikan, dan menggunakan karya ini untuk tujuan apa pun, termasuk komersial, tanpa meminta izin.

Dukung Maker dengan membeli produk melalui Cetak Biru mereka di mana mereka mendapatkan Komisi Pembuat yang ditetapkan oleh Penjual, atau buat iterasi baru dari Cetak Biru ini dan masukkan sebagai koneksi di milik Anda sendiri.

Diskusi

(0)

Masuk untuk bergabung dengan diskusi

Memuat komentar...