SENI
KECANTIKAN & KESEHATAN
KERAJINAN
BUDAYA & SEJARAH
HIBURAN
LINGKUNGAN
MAKANAN & MINUMAN
REKAYASA BALIK
ILMU PENGETAHUAN
OLAHRAGA
TEKNOLOGI
PERANGKAT PAKAI
Uninked Ribbon Fabric: Nylon with a Crimped Filler, Relaxed in Soap (Thompson, US 2,918,160, 1959)
Charlie

Dibuat oleh

Charlie

31. Oktober 2026DE
1
0
0
0
0

Uninked Ribbon Fabric: Nylon with a Crimped Filler, Relaxed in Soap (Thompson, US 2,918,160, 1959)

Nylon ribbons wear well but hold little ink; cotton holds more but frays under the type. Thompson wove nylon with a crimped filler held taut; relaxed after weaving, the crimped filaments spring apart into tiny pockets that store ink, while the surface stays flat. Result: a thin nylon ribbon fabric, about 167 x 100 per inch, that held ink for about twice as many lines. Source: Thompson, US 2,918,160 (1959). Picture drawn by Youblob.
Lanjutan
Factory process

Instruksi

1

Crimp the filler yarn

Give 40-denier, 34-filament nylon (5 turns twist) heat-set crimps, about 64 per inch. Thompson points to US 2,575,838 for the crimping. Ours: Nylon Thread by kind.

Material untuk langkah ini:

Benang nilonBenang nilon1 as required

Alat yang dibutuhkan:

Mesin pengeriting benangMesin pengeriting benang
2

Weave it under tension

Plain weave at loom width: warp 40-denier, 34-filament nylon, 7 turns twist, about 148 per inch; crimped filler 100 per inch, kept stretched so the crimps are held out while weaving. Heavy duty: 70 denier.

Material untuk langkah ini:

Benang nilonBenang nilon1 as required

Alat yang dibutuhkan:

Alat tenun mesinAlat tenun mesin
3

Relax in warm soap and dry loose

Soak the fabric in a neutral soap solution at about 90 °F, then dry it without a frame. The crimps come back and open pockets among the filaments; the surface must stay flat.

Alat yang dibutuhkan:

SabunSabun
4

Cut into ribbons, sealing the edges

Scour, then cut into ribbon widths with the crimped yarn running across the ribbon. A heated cutter seals the edges. Finished count about 167 x 100; a filler of 95-110 per inch works.

Alat yang dibutuhkan:

Pemotong pita panasPemotong pita panas

Bahan

1
  • 2 as required
    Placeholder

Alat yang Diperlukan

4

Blueprint terkait

Blueprint ini berbagi pengetahuan — teknik, bahan, atau prinsip

CC0 Domain Publik

Cetak biru ini dirilis di bawah CC0. Anda bebas untuk menyalin, memodifikasi, mendistribusikan, dan menggunakan karya ini untuk tujuan apa pun, termasuk komersial, tanpa meminta izin.

Dukung Maker dengan membeli produk melalui Cetak Biru mereka di mana mereka mendapatkan Komisi Pembuat yang ditetapkan oleh Penjual, atau buat iterasi baru dari Cetak Biru ini dan masukkan sebagai koneksi di milik Anda sendiri.

Diskusi

(0)

Masuk untuk bergabung dengan diskusi

Memuat komentar...