همکاری
هنر
زیبایی و سلامت
صنایع دستی
فرهنگ و تاریخ
سرگرمی
محیط زیست
غذا و نوشیدنی
مهندسی معکوس
علوم
ورزش
فناوری
پوشیدنی‌ها
Bismuth: Sweated Out of Native Ore in Inclined Iron Tubes, the Schneeberg Way (Thorpe, 1912)
Charlie

ایجاد شده توسط

Charlie

4. نوامبر 2026DE
۱۳
۰
۰
۰
۰

Bismuth: Sweated Out of Native Ore in Inclined Iron Tubes, the Schneeberg Way (Thorpe, 1912)

The old way of getting bismuth from ore that holds it as the metal: heat the lumps just enough in sloping iron tubes and the bismuth, which melts easily, runs out of the rock into pots under charcoal. It takes 30-60 minutes a charge but gets only about two-thirds of the metal. Not given: the furnace temperature. Source: E. Thorpe, Dictionary of Applied Chemistry vol. I (1912), Bismuth, p. 458. Picture: Thorpe's Fig. 1, the furnace in plan.
متوسط
30-60 minutes per charge

دستورالعمل‌ها

1

Pick and break the ore

Sort the ore (7-12 % bismuth) by hand from the waste rock as far as possible and break it into pieces the size of a hazel nut.

مواد مورد نیاز این مرحله:

سنگ بیسموت خالصسنگ بیسموت خالص1 12 cwt per tube charge

ابزارهای مورد نیاز:

چکشچکش
باسکول سکویی صنعتیباسکول سکویی صنعتی
2

Charge the tubes

Load about 12 cwt into each inclined iron tube of the furnace, leaving room to stir from the upper end. Close the upper ends with iron plates and the lower ends with plates pierced with round holes. Under each lower end stand an iron pot holding powdered charcoal, kept gently warm by a small charcoal fire.

مواد مورد نیاز این مرحله:

زغال چوبزغال چوب1 powdered, in the pots and for the pot fire

ابزارهای مورد نیاز:

کوره ذوب‌جداسازی بیسموتکوره ذوب‌جداسازی بیسموت
بوتهٔ چدنیبوتهٔ چدنی
3

Sweat out the bismuth

Fire the furnace with wood so that the metal flows easily. In about 10 minutes the bismuth begins to run into the pots, where the charcoal covers it from the air. Stir the ore now and then with an iron rod from the upper end; in 30-60 minutes the charge is done. 20 cwt of ore burns about 63 cubic feet of wood.

مواد مورد نیاز این مرحله:

هیزمهیزم1 about 63 cu ft per 20 cwt of ore

ابزارهای مورد نیاز:

کوره ذوب‌جداسازی بیسموتکوره ذوب‌جداسازی بیسموت
میلهٔ گرد آهنیمیلهٔ گرد آهنی
4

Rake out and recharge

Rake the spent ore (bismuth barley) out of the upper end into the tank and refill at once with fresh ore.

ابزارهای مورد نیاز:

شن‌کش آهنیشن‌کش آهنی
کوره ذوب‌جداسازی بیسموتکوره ذوب‌جداسازی بیسموت
5

Cast ingots

Ladle the bismuth from the pots into moulds and cast ingots of 25-50 lb.

ابزارهای مورد نیاز:

بوتهٔ چدنیبوتهٔ چدنی
ملاقهٔ ریخته‌گریملاقهٔ ریخته‌گری
قالب شمشقالب شمش

مواد

3
  • 1 12 cwt per tube charge
    جایگزین
  • 1 powdered, in the pots and for the pot fire
    جایگزین
  • 1 about 63 cu ft per 20 cwt of ore
    جایگزین

ابزارهای لازم

8

این نقشه می‌سازد

CC0 مالکیت عمومی

این نقشه تحت مجوز CC0 منتشر شده است. شما آزاد هستید آن را کپی، ویرایش، توزیع و برای هر هدفی بدون نیاز به اجازه استفاده کنید.

با خرید محصولات از طریق نقشه از سازنده حمایت کنید و او کمیسیون سازنده تعیین شده توسط فروشندگان، دریافت می‌کند یا یک نسخه جدید از این نقشه ایجاد کنید و آن را به عنوان اتصال در نقشه خود قرار دهید تا درآمد به اشتراک گذاشته شود.

بحث و گفتگو

(0)

ورود برای شرکت در بحث

در حال بارگذاری نظرات...