همکاری
هنر
زیبایی و سلامت
صنایع دستی
فرهنگ و تاریخ
سرگرمی
محیط زیست
غذا و نوشیدنی
مهندسی معکوس
علوم
ورزش
فناوری
پوشیدنی‌ها
Function Generator: Resistance-Capacity Tuned Audio Oscillator with Lamp Amplitude Control (Hewlett, US 2,268,872, 1942)
Ed

ایجاد شده توسط

Ed

3. نوامبر 2026FI
۱۳
۰
۰
۰
۰

Function Generator: Resistance-Capacity Tuned Audio Oscillator with Lamp Amplitude Control (Hewlett, US 2,268,872, 1942)

The first Hewlett-Packard product: a test oscillator tuned by resistors and capacitors instead of coils. Two valve amplifiers feed their output back to their input through a series and a parallel R-C pair, which passes only one frequency in phase, so the circuit oscillates there. A second, negative feedback path through a small lamp holds the amplitude steady: as the swing grows the lamp warms, its resistance rises and the gain falls. One dial covers ten to one in frequency. Result: a sine-wave signal generator covering 20 to 20,000 cycles in three ranges, about 0.25 % distortion. Source: W. R. Hewlett, US 2,268,872 (1942). Unknown: valve types and component values. Picture: the patent drawing.
پیشرفته
Unknown

دستورالعمل‌ها

1

Build the two-stage amplifier

Wire two amplifying valves in cascade with resistance-capacity coupling, the first's anode to the second's grid, run as class A amplifiers. Not given: valve types, values, the supplies. Ours: pentode valves in sockets.

مواد مورد نیاز این مرحله:

لامپ پنتودلامپ پنتود2 قطعه
سوکت لامپسوکت لامپ2 قطعه
مقاومتمقاومت1 مجموعه
کیت خازنکیت خازن1 coupling and by-pass
جعبهٔ آلومینیومیجعبهٔ آلومینیومی1 case
سیم لحیمسیم لحیم1 as needed

ابزارهای مورد نیاز:

هویههویه
2

Fit the tuning network

From the second valve's anode, through a coupling capacitor, feed back to the first valve's grid through a resistor R1 in series with a variable capacitor C1, with a resistor R2 and variable capacitor C2 from the grid to ground. Make R1 = R2 and C1 = C2: the frequency is then 1/(2 pi R C), set by the capacitors, giving 10 to 1 on one dial. For the capacitors use a four-gang tuning capacitor with its sections paired in parallel. Switch three sets of resistors in for the ranges 20-200, 200-2000 and 2000-20,000 cycles. Ours: a rotary switch.

مواد مورد نیاز این مرحله:

خازن متغیر (دی‌الکتریک هوا)خازن متغیر (دی‌الکتریک هوا)1 four-gang
مقاومتمقاومت1 three sets of R1, R2
کلید چرخانکلید چرخان1 range switch

ابزارهای مورد نیاز:

هویههویه
مجموعه پیچ‌گوشتیمجموعه پیچ‌گوشتی
3

Fit the lamp feedback and use it

From the same output, through the coupling capacitor, feed back to the first valve's cathode across a resistor R4 and a small incandescent lamp R3. As the oscillation grows, the lamp heats, its resistance rises, the negative feedback increases and the gain falls, so the amplitude settles below the point of grid current with no clipping. The negative feedback also steadies the gain against valve and supply changes. Take the output from the terminals; Hewlett's test unit held its output within about 10 % over 20-20,000 cycles, with about 0.25 % distortion and under 0.1 % frequency shift with supply changes.

مواد مورد نیاز این مرحله:

لامپلامپ1 small incandescent lamp
مقاومتمقاومت1 R4
پست اتصالپست اتصال2 output

ابزارهای مورد نیاز:

منبع تغذیهٔ جریان مستقیممنبع تغذیهٔ جریان مستقیم
هویههویه

مواد

10
  • جایگزین
  • جایگزین
  • جایگزین
  • 1 coupling and by-pass
    جایگزین
  • جایگزین
  • 1 as needed
    جایگزین
  • جایگزین
  • 1 range switch
    جایگزین
  • 1 small incandescent lamp
    جایگزین
  • 2 output
    2 vendors sell this, none ship to you yet
    جایگزین

ابزارهای لازم

3

این نقشه می‌سازد

CC0 مالکیت عمومی

این نقشه تحت مجوز CC0 منتشر شده است. شما آزاد هستید آن را کپی، ویرایش، توزیع و برای هر هدفی بدون نیاز به اجازه استفاده کنید.

با خرید محصولات از طریق نقشه از سازنده حمایت کنید و او کمیسیون سازنده تعیین شده توسط فروشندگان، دریافت می‌کند یا یک نسخه جدید از این نقشه ایجاد کنید و آن را به عنوان اتصال در نقشه خود قرار دهید تا درآمد به اشتراک گذاشته شود.

بحث و گفتگو

(0)

ورود برای شرکت در بحث

در حال بارگذاری نظرات...