همکاری
هنر
زیبایی و سلامت
صنایع دستی
فرهنگ و تاریخ
سرگرمی
محیط زیست
غذا و نوشیدنی
مهندسی معکوس
علوم
ورزش
فناوری
پوشیدنی‌ها
Rubber Compound: Raw Rubber Washed, Dried and Mixed with Sulphur on Hot Rolls (Thorpe, 1913)
Charlie

ایجاد شده توسط

Charlie

4. نوامبر 2026DE
۱۱
۰
۰
۰
۰

Rubber Compound: Raw Rubber Washed, Dried and Mixed with Sulphur on Hot Rolls (Thorpe, 1913)

How a rubber works of 1913 turned raw rubber into a 'mixing' ready for shaping and curing: the rubber is washed between corrugated rolls under running water, dried on racks, broken down on hot smooth rolls until plastic, and then worked together with fillers and finally sulphur into an even dough. Very few goods were made of rubber and sulphur alone: pure mixings cost too much and are too soft for most uses. Unknown: which fillers, and how much of them and of sulphur. Thorpe names the kinds of materials but gives no mixing. Source: T. E. Thorpe, Dictionary of Applied Chemistry vol. IV (1913), pp. 586-587. Picture: Fig. 1, a washing machine.
متوسط
3-4 days drying

دستورالعمل‌ها

1

Steep and wash the rubber

Cut the raw rubber into lumps or slabs and steep them for some hours in warm water. Pass them again and again through corrugated, diamond-cut or fluted rolls running at a speed difference of 6 : 4 down to one tooth, with a stream of water on the rubber, until the rough crepe-like sheet is clean and thin.

مواد مورد نیاز این مرحله:

ورق کائوچوی دودیورق کائوچوی دودی1 raw rubber
آبآب1 warm, then running

ابزارهای مورد نیاز:

میکسر دوغلتکهٔ لاستیکمیکسر دوغلتکهٔ لاستیک
2

Dry on racks

Hang the sheet on racks in a drying room until it holds only about 0.25-0.5 per cent moisture: about 3-4 days at about 80°F with good ventilation. Cooler, drier air is better, as warm rubber turns soft and tacky.

ابزارهای مورد نیاز:

قفسه خشک‌کنقفسه خشک‌کن
3

Break it down

Pass the dry rubber repeatedly through the steam-heated smooth rolls of the mixing machine, which run at different speeds, tightening the rolls gradually until the rubber is thoroughly plastic.

ابزارهای مورد نیاز:

میکسر دوغلتکهٔ لاستیکمیکسر دوغلتکهٔ لاستیک
4

Mix in the fillers and sulphur

Add the other materials gradually: reclaimed rubber, ground waste, 'substitute' and other organic fillers first, then the minerals and the sulphur last. Work it into a thoroughly even dough without overworking ('tiring') the rubber.

مواد مورد نیاز این مرحله:

ماده ناشناختهماده ناشناخته1 fillers and minerals; not given
پودر گوگردپودر گوگرد1 amount not given

ابزارهای مورد نیاز:

میکسر دوغلتکهٔ لاستیکمیکسر دوغلتکهٔ لاستیک

مواد

4
  • جایگزین
  • 1 warm, then running
    جایگزین
  • 1 fillers and minerals; not given
    جایگزین
  • 1 amount not given
    جایگزین

ابزارهای لازم

2

این نقشه می‌سازد

CC0 مالکیت عمومی

این نقشه تحت مجوز CC0 منتشر شده است. شما آزاد هستید آن را کپی، ویرایش، توزیع و برای هر هدفی بدون نیاز به اجازه استفاده کنید.

با خرید محصولات از طریق نقشه از سازنده حمایت کنید و او کمیسیون سازنده تعیین شده توسط فروشندگان، دریافت می‌کند یا یک نسخه جدید از این نقشه ایجاد کنید و آن را به عنوان اتصال در نقشه خود قرار دهید تا درآمد به اشتراک گذاشته شود.

بحث و گفتگو

(0)

ورود برای شرکت در بحث

در حال بارگذاری نظرات...