هنر
زیبایی و سلامت
صنایع دستی
فرهنگ و تاریخ
سرگرمی
محیط زیست
غذا و نوشیدنی
مهندسی معکوس
علوم
ورزش
فناوری
پوشیدنیها

Sew-In Interfacing: Cotton Shrunk Overnight Before Cutting
The cloth basted inside a collar or coat front to give it body is only useful if it has been shrunk first: otherwise, as Butterick's New Dressmaker (1921) warns, it "will shrink on the first damp day and will draw in and wrinkle the coat". This is the book's sponging method: roll the cloth up with a damp muslin overnight, press it dry, then cut it by the pattern.
Butterick names soft canvas, cotton serge or cambric for wool, and butchers' linen, cambric or muslin for linen; ours is cotton muslin. The picture: the book's Ill. 102.
مبتدی
Overnight + 30 minutes
دستورالعملها
1
1
Choose the cloth
Choose the cloth
For wool: soft pliable canvas, cotton serge or cambric. For linen: butchers' linen, cambric or muslin. For silk: cotton serge, sateen or cambric. Ours: cotton muslin.
مواد مورد نیاز این مرحله:
پارچهٔ ململ پنبهای1 قطعه2
2
Clip the selvedge
Clip the selvedge
Cut off the selvedge, or clip it at intervals, so it cannot pull the cloth as it shrinks.
ابزارهای مورد نیاز:
قیچی3
3
Lay it out
Lay it out
Lay the cloth face down on the table over an ironing blanket. Ours: the ironing board.
ابزارهای مورد نیاز:
تختهٔ اتو4
4
Damp the sponging cloth
Damp the sponging cloth
Wet a strip of heavy unbleached muslin, as wide as your cloth and half as long, in cold water and wring it out.
ابزارهای مورد نیاز:
پارچهٔ ململ
آب5
5
Fold and roll
Fold and roll
Spread it without wrinkles over half the cloth, fold the other half over it, and roll the two up tightly together.
ابزارهای مورد نیاز:
پارچهٔ ململ6
6
Leave it overnight
Leave it overnight
Leave the roll overnight, covered with a piece of muslin and some newspapers to keep the moisture in.
ابزارهای مورد نیاز:
پارچهٔ ململ
کاغذ روزنامه (لایی)7
7
Unroll and press dry
Unroll and press dry
In the morning unroll it, pressing the cloth dry on the wrong side as you go.
ابزارهای مورد نیاز:
اتوی لباس
تختهٔ اتو8
8
Cut by the pattern
Cut by the pattern
Cut the interfacing by the garment pattern. For a strictly tailored collar, cut it 3/8 inch smaller than the pattern at all edges. Baste it to the wrong side of the garment.
ابزارهای مورد نیاز:
قیچیمواد
1- 1 قطعهجایگزین
این نقشه میسازد
نقشههای مرتبط
این نقشهها دانش مشترکی دارند — تکنیکها، مواد یا اصول
CC0 مالکیت عمومی
این نقشه تحت مجوز CC0 منتشر شده است. شما آزاد هستید آن را کپی، ویرایش، توزیع و برای هر هدفی بدون نیاز به اجازه استفاده کنید.
با خرید محصولات از طریق نقشه از سازنده حمایت کنید و او کمیسیون سازنده تعیین شده توسط فروشندگان، دریافت میکند یا یک نسخه جدید از این نقشه ایجاد کنید و آن را به عنوان اتصال در نقشه خود قرار دهید تا درآمد به اشتراک گذاشته شود.

