همکاری
هنر
زیبایی و سلامت
صنایع دستی
فرهنگ و تاریخ
سرگرمی
محیط زیست
غذا و نوشیدنی
مهندسی معکوس
علوم
ورزش
فناوری
پوشیدنیها

Thompson (Nlaka'pamux) Winter Pit House: Circle Laid Out with Two Crossed Ropes, Four Rafters on Braces, Earth-Covered, Notched-Log Ladder (Teit, 1900)
The Thompson (Nlaka'pamux) winter house as James Teit recorded it: a round pit 20 to 40 ft across laid out with two crossed bark ropes, four main rafters set two feet into the ground and resting on notched braces, side rafters and cross poles tied with willow, covered with split wood, pine needles and stamped earth, and entered down a notched log through the square smoke hole.
پیشرفته
One day with twenty or thirty people
دستورالعملها
1
1
His measures
His measures
در حال بارگذاری دفترچهٔ Jupyter…
2
2
Read Teit
Read Teit
"Though inconvenient, they were extremely warm."
3
3
Lay out the circle
Lay out the circle
Pick a spot with loose soil near water. Knot two bark ropes at the same length, 20 to 40 ft (6-12 m) for the diameter. Cross them at right angles, finding the middle by eye or by folding them. Stake the centre and the four ends, and scratch a circle through the four outer stakes with a stick.
مواد مورد نیاز این مرحله:
طناب1 قطعهابزارهای مورد نیاز:
میخ چادر
چاقو4
4
Dig the pit
Dig the pit
Dig out the circle with digging sticks and flat-bladed scrapers and carry the earth out in baskets; pile it nearby for the roof. Teit gives no depth; ours: about 1.2-1.5 m.
ابزارهای مورد نیاز:
چوب کندن
بیل
سبد5
5
Cut the timbers
Cut the timbers
Cut green trees for the heavy posts, sized to the pit by eye with a bark rope, bark them and haul them in with stout rope; they need not be squared. Cut and bark thin roof poles and bundle them.
مواد مورد نیاز این مرحله:
تیرک چوب تر1 قطعه
تیرک چوبی1 قطعهابزارهای مورد نیاز:
تبر
تیشه
گوههای چوبی
چکش چوبی6
6
Raise the frame
Raise the frame
Set four upright braces about 15 in. (38 cm) deep, stamping and beating the earth firm, with notched tops. Set the four main rafters' butts about 2 ft (60 cm) deep at the four marked points (lines NE-SW and NW-SE), resting on the braces and tied with willow withes; they do not meet in the middle. Lean side rafters against them from the ground. Tie horizontal poles across 30-60 cm apart, closer above the joints, and join the rafter tops with four heavy timbers to frame the square entrance.
مواد مورد نیاز این مرحله:
تیرک چوب تر1 قطعه
تیرک چوبی1 قطعه
ترکهٔ بید1 قطعهابزارهای مورد نیاز:
تبر
چاقو
چکش چوبی7
7
Cover it
Cover it
Lay poles or split wood from the ground up to the entrance (not tied), cover them with pine needles or dry grass, then with the dug earth, beaten and stamped down hard. In wet country line it with cedar bark, inner side out.
مواد مورد نیاز این مرحله:
تیرک چوبی1 قطعه
یونجهٔ خشک1 قطعهابزارهای مورد نیاز:
بیل
سبد8
8
Ladder and hearth
Ladder and hearth
Cut a big log with notches as a ladder, with a groove down its back for the hand. Stand it nearly upright from near the centre up through the entrance, lashed against the west side, top leaning slightly east. Put the fire at its foot behind a stone slab that shields the log.
مواد مورد نیاز این مرحله:
تیرک چوب تر1 قطعه
لوح سنگی تخت1 قطعه
طناب1 قطعهابزارهای مورد نیاز:
تبر
تیشه9
9
Troubleshooting
Troubleshooting
Pit house troubleshooting.
Flow
Loading...
10
10
History and honest limits
History and honest limits
From James Teit, *The Thompson Indians of British Columbia*, **Memoirs of the American Museum of Natural History, Jesup North Pacific Expedition** vol. I part IV (1900), pp. 192-194 and Figs. 135-136 (checked on the archive.org scan cihm_16242). Houses held fifteen to thirty people and were lived in from December to February or March; entering, you called out 'A'la!' so the cooks could cover the food. The ladder top was often carved or painted. Teit gives no pit depth: ours.
مواد
6- 2 قطعهجایگزین
- 1 قطعهجایگزین
- 1 قطعهجایگزین
- 1 قطعهجایگزین
- 1 قطعهجایگزین
- 1 قطعهجایگزین
این نقشه میسازد
نقشههای مرتبط
این نقشهها دانش مشترکی دارند — تکنیکها، مواد یا اصول
CC0 مالکیت عمومی
این نقشه تحت مجوز CC0 منتشر شده است. شما آزاد هستید آن را کپی، ویرایش، توزیع و برای هر هدفی بدون نیاز به اجازه استفاده کنید.
با خرید محصولات از طریق نقشه از سازنده حمایت کنید و او کمیسیون سازنده تعیین شده توسط فروشندگان، دریافت میکند یا یک نسخه جدید از این نقشه ایجاد کنید و آن را به عنوان اتصال در نقشه خود قرار دهید تا درآمد به اشتراک گذاشته شود.


