LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
GRÆN FRAMTÍÐ
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI

Building a Cajón — The Peruvian Box Drum You Sit On
Build a cajón: a plywood box drum you sit on and play with your bare hands, with guitar-string snares behind the front face that buzz. Cut the box, fit the thin playing face, string the snare, and assemble. A buildable school/maker project in the plate drum and the snare — a deep bass in the middle, a crisp buzzing crack at the top.
Byrjandi
2-3 hours
Leiðbeiningar
1
1
A drum you sit on
A drum you sit on
The cajón is a wooden box you sit on and slap with your bare hands. The thin front face is the drumhead; guitar-string snares behind it buzz. Hit the middle for a deep BASS, the top edge for a crisp snappy SLAP.
2
2
Cut the box panels
Cut the box panels
Cut five panels of thick plywood — two sides, a top, a bottom and a back — for a box about the size to sit on (roughly 30 x 30 x 48 cm). These stiff walls stay silent; they are just the soundbox.
Efni fyrir þetta skref:
Baltic Birch Plywood (3/4 inch, 24x30)1 pieceNauðsynleg verkfæri:
Hacksaw3
3
Cut the sound hole
Cut the sound hole
Cut a round hole (about 10-12 cm) in the BACK panel. This port lets the boom of air out and tunes the bass, exactly like the hole in a guitar or the open foot of a djembe.
Nauðsynleg verkfæri:
Awl4
4
Make the tapa (playing face)
Make the tapa (playing face)
Cut the front face (the tapa) from THIN plywood. This is the only part that is meant to vibrate — the box's drumhead. It will be screwed firmly at the top and bottom but left slightly loose at the top corners so the corners can slap.
Efni fyrir þetta skref:
Baltic Birch Plywood (1/8 inch, 12x12, 10-Pack)1 piece5
5
Fit the snare
Fit the snare
Stretch two or three guitar strings at an angle up the INSIDE of the tapa, touching it lightly. When the tapa is struck it rattles the strings — this buzz is the cajón's built-in snare, its signature sizzle.
Efni fyrir þetta skref:
Guitar String Set (Acoustic, Phosphor Bronze)1 piece6
6
Assemble the box
Assemble the box
Glue and screw the five thick panels into a box, then screw the thin tapa on across the open front — tight at top and bottom, with the top corners left free to snap.
Efni fyrir þetta skref:
PVA Wood Glue1 piece
#8 x 1" Wood Screw24 piece7
7
Sit down and play
Sit down and play
Sit on top of the box and play the tapa between your knees. Strike the CENTRE with a flat hand for the deep bass 'doom'; strike the TOP EDGE with your fingers for the buzzing snare 'crack'. Those two strokes are the whole groove.
8
8
Compendium — the plate drum with a snare
Compendium — the plate drum with a snare
The cajón is unusual: its 'drumhead' is not a stretched skin but a thin sheet of WOOD (the tapa), so it is really a plate drum. Struck in the middle, the whole plate flexes inward and pumps a slug of air around the sealed box and out of the back port — the box acting as a Helmholtz resonator (a bottle blown at its own pitch) to boom out a deep BASS, the same job the open foot does on a djembe. Struck near the top edge, only the loosely-fixed corner of the plate snaps and springs, giving a bright dry crack with little body. Laid against the inside of that plate are the snares — a few guitar strings under light tension — and every time the plate moves it shakes the strings, which rattle against it and add a sizzling buzz on top of the note; it is a deliberate BUZZER, the very same idea as the mbira's rattling shells or the dizi's buzzing membrane, an African aesthetic that a clean tone is less alive than a buzzing one. That African root is no accident: the cajón was built by enslaved Africans in colonial Peru, said to be improvised from shipping crates when drums were forbidden, and its bass-and-slap hand technique is the box-shaped cousin of the djembe. From those crates it has grown into a staple of flamenco, folk and pop worldwide — proof that a plywood box, thought through, is a complete drum kit.
Efni
5- Staðgengill
- Staðgengill
- Staðgengill
- 1 pieceStaðgengill
- 24 pieceStaðgengill
You can swap these in
Can't get one of the materials? Swap it for an equivalent — these work just as well.
- Instead of PVA Wood Glue, try:
Polyurethane Glue
Wood Glue - Instead of Baltic Birch Plywood (1/8 inch, 12x12, 10-Pack), try:
CDX Softwood Plywood
Fire-Rated Plywood
Oak Hardwood Plywood - Instead of #8 x 1" Wood Screw, try:
M8 Socket Head Cap Screw
M4 Flat Head Machine Screw
M6 Flat Head Machine Screw
Fine Thread Drywall Screw
#10-24 Machine Screw
M4 Cup Point Set Screw - Instead of Awl, try:
Bone Awl
Tengd Blueprint
Þessi blueprint deila þekkingu — tækni, efni eða meginreglur
Related blueprints
Other builds that share materials, tools, or techniques with this one.

Building a Santur — The Persian Hammered Dulcimer

Building a Balafon — The West African Gourd-Resonated Xylophone

Building a Macadam Road — Cheap, Dry Highways from Small Broken StoneENGINEERING

Building a Langspil — The Icelandic Drone Zither

Building a Sheng — The Chinese Free-Reed Mouth Organ

Building a Janggu — The Korean Hourglass Drum
CC0 opinbert ríki
Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.
Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.