Samvinna
LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI
Lead Came Mould: Two Hinged Grooved Irons (Theophilus, tr. Hendrie 1847)
The iron mould in which Theophilus cast the lead rods of glass windows: two irons a yard long, hinged at one end with a nail, filed to close without a chink of light, with a matching groove hollowed down the middle of each so the lead poured in makes one rod.
The free ends are made a little wider and thinner to form a pouring mouth, and the two halves are keyed so they cannot slip while casting.
Source: Theophilus, De Diversis Artibus, Book II, ch. XXIV, tr. R. Hendrie (1847), p. 147. Picture: the chapter.
Miðlungs
Unknown
Leiðbeiningar
1
1
Hinge the irons
Hinge the irons
Take two irons two fingers broad, one finger thick and a yard long. Join them at one end like a hinge, fastened by a nail, so they open and shut. Make the other ends a little wider and thinner, so that when shut they form the start of a cavity (the pouring mouth). Not given: how the hinge is formed.
Efni fyrir þetta skref:
Stengur úr smíðajárni2 2 fingers x 1 finger x 1 yard
Naglar1 hinge pinNauðsynleg verkfæri:
Hamar2
2
Fit the faces
Fit the faces
Let the outer sides lie even, and file the two faces together until no light shows between them when closed.
Nauðsynleg verkfæri:
Málmþjöl3
3
Cut the grooves
Cut the grooves
Open the irons. With a rule, draw two narrow lines down the middle of each piece, facing each other, from top to bottom. Hollow out between them with the chasing iron used for hollowing lamps, as deep as you wish, and rasp a little inside so the lead poured in makes one piece. Key the mouth so one half cannot slip on the other while casting.
Nauðsynleg verkfæri:
Reglustika
RaspEfni
2- 2 2 fingers x 1 finger x 1 yardStaðgengill
- 1 hinge pinStaðgengill
Þessi teikning býr til
CC0 opinbert ríki
Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.
Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.