Samvinna
LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI
Platinum Crucible: Shaped from Foil in a Hollow in a Board (Morfit, 1849)
A small platinum crucible for igniting precipitates at high heat. Campbell Morfit (1849): "The experimenter himself can in any emergency readily form a crucible out of platinum foil by shaping it with the thumb or a small hammer, in a hemispherical cavity made in a board for the purpose."
Platinum crucibles must be of pure metal and hammered, not turned; thin enough to weigh on a delicate balance. Foil thickness and the size of the hollow are not given.
Source: C. Morfit, Chemical and Pharmaceutic Manipulations (1849), pp. 196-197. Picture: Fig. 164.
Byrjandi
Unknown
Leiðbeiningar
1
1
Read Morfit
Read Morfit
"The experimenter himself can in any emergency readily form a crucible out of platinum foil by shaping it with the thumb or a small hammer, in a hemispherical cavity made in a board for the purpose."
2
2
Make the hollow
Make the hollow
Cut a hemispherical cavity in a board, the size of the crucible wanted. Morfit's crucibles hold from a fluidrachm to three fluid ounces; a half-ounce one is the most needed in analysis. How the cavity is cut is not given (ours: a gouge in a hardwood board).
Nauðsynleg verkfæri:
Harðviðarborð
Holjárn
Óþekkt mál3
3
Shape the foil
Shape the foil
Lay a piece of pure platinum foil over the hollow and press it in with the thumb, or work it in with a small hammer, until it takes the hemispherical shape. The foil thickness, and how the foil is made, are not given (unknown).
Efni fyrir þetta skref:
Platína1 foilNauðsynleg verkfæri:
Harðviðarborð
Kúluhamar
Óþekkt mótunaraðferð4
4
Care of the crucible
Care of the crucible
Blisters and flaws that appear after use come from impure metal and bad workmanship; remove them by the force of a small hammer. Loosen salts with boiling water and rub off stains with sand or pumice stone. Do not use sharp pointed instruments on it.
Nauðsynleg verkfæri:
KúluhamarÞessi teikning býr til
CC0 opinbert ríki
Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.
Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.