Samvinna
LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI
Alcohol Burner: the Glass Spirit Lamp with a Copper Wick Shield (Morfit, 1849)
A small glass lamp that burns alcohol for heating test tubes and small vessels on the bench. Campbell Morfit (1849): the glass body holds the alcohol; a round copper shield with a tube in its centre carries a cotton wick and rests on the neck; a minute hole in the shield lets vapour escape; a glass cap ground to fit the neck keeps the alcohol from evaporating.
Alcohol gives no smoke and does not blacken the glass. Sizes, and how the wick tube is fixed, are not given.
Source: C. Morfit, Chemical and Pharmaceutic Manipulations (1849), pp. 160-162. Picture: Fig. 115.
Byrjandi
Unknown
Leiðbeiningar
1
1
Read Morfit
Read Morfit
"To the neck b is adjusted a copper circular shield c, with a tube in its centre for the passage of the wick, which should be of cotton, and similar to that used for tallow candles. The shield should rest upon, rather than within the neck, otherwise its expansion by the heat may cause the breakage of the glass. A minute opening drilled in the shield is also requisite for the escape of vapor in case the alcohol should become heated."
2
2
Make the copper shield
Make the copper shield
Cut a round copper shield a little wider than the neck of the glass body, so it rests on the neck and not inside it. Fix a short copper tube through its centre for the wick (ours: soldered; the joint is not given). Drill a minute hole in the shield for vapour to escape. Sizes are not given (unknown).
Efni fyrir þetta skref:
Koparplata1 shield
Koparrör1 wick tube
Tin-blý lóðmálmur1 joint
Lóðfeiti1 jointNauðsynleg verkfæri:
Plötuklippur
Lóðbolti
Handbor
Óþekkt mál3
3
Fit the wick and the body
Fit the wick and the body
Draw a cotton wick of the tallow-candle kind through the tube so it reaches down into the glass body, which is the alcohol reservoir. Set the shield on the neck. Ours: a clear glass bottle as the body.
Efni fyrir þetta skref:
Glerflaska (glær)1 body
Kertakveikur úr bómull1 stykkiNauðsynleg verkfæri:
Plötuklippur4
4
Fit the glass cap
Fit the glass cap
Cover the wick, when the lamp is not in use, with a glass cap ground inside to fit the neck closely. It stops the alcohol evaporating and the wick taking up water, which makes relighting difficult. Put it on only after the lamp is out. How the cap is made and ground is not given (unknown).
Efni fyrir þetta skref:
Óþekkt gler1 capNauðsynleg verkfæri:
Óþekkt mál5
5
Fill and use
Fill and use
Morfit burns alcohol of about specific gravity 0.85. Always put the lamp out before refilling, then pour the spirit in gently until the reservoir is nearly full. The flame is hottest just below its tip; bring the vessel to it gradually, and spread the heat with copper gauze between flame and vessel for larger surfaces.
Efni
7- 1 shieldStaðgengill
- 1 wick tubeStaðgengill
- 1 jointStaðgengill
- 1 jointStaðgengill
- 1 bodyStaðgengill
- 1 stykkiStaðgengill
- 1 capStaðgengill
Þessi teikning býr til
CC0 opinbert ríki
Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.
Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.