LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI

The Tipping-Platform Rat Trap: A Disk That Rights Itself
A spring trap catches one animal and must then be emptied and set again. A trap that sets itself again can keep working through the night.
Seaborn H. B. Harwell of Morgan County, Georgia, received US 290,580, dated 18 December 1883, for a rat-trap in which a light disk hangs from a rod laid across a vessel. The disk is weighted beneath so that it hangs level, tips when an animal steps onto it, drops the animal into the vessel and swings back "ready to entrap the next comer".
This rung works out why a light disk tips for a rat and rights itself, then builds the tipping platform over a tall, dry bucket.
Byrjandi
About 2 hours
Leiðbeiningar
1
1
How far the disk tips
How far the disk tips
Hleð Jupyter-vinnubók…
2
2
A trap that sets once
A trap that sets once
The embedded blueprint builds a deadfall, which springs once and must be set again by hand. Harwell's disk sets itself again after every catch.
3
3
Read US 290,580
Read US 290,580
"The disk I prefer to make of light wood, so that it will tilt very easily when even a slight weight is put upon it."
"As rats and mice are very wary and cunning, I contemplate for the first night or two inserting the locking-pins K K, so as to render the disk immovable. After they have got accustomed to coming to the trap for their food, with which it is baited each night, and to playing over the disk or platform, the trap is again set with the locking-pins removed."
"As said platform is situated below the points of support from which it is hung, it will, as soon as it has turned up vertically and deposited the rat, turn back again immediately into a horizontal position, ready to entrap the next comer."
4
4
Build the tipping platform over a dry bucket
Build the tipping platform over a dry bucket
Cut a disk from thin plywood about 2 cm smaller than the bucket's mouth, so it can turn inside the rim without touching it. Draw a line across its centre. Screw two screw eyes into its top face on that line, one near each edge. Screw three or four washers to the centre of its underside as the balancing weight.
Saw two notches opposite each other in the bucket's rim. Push the dowel through the screw eyes and lay its ends in the notches. Add or remove washers until the disk hangs level and swings back when you tip it.
Drill two small holes through the bucket wall just under the disk's edge, opposite each other and at right angles to the dowel. Push a nail through each hole so it props the disk, and tie each nail to the bucket with string. Weigh out a 20 g and a 250 g object on the scale, set each in turn 6 cm from the dowel, and compare the tilt with the notebook.
Lean a board against the bucket as a ramp. Put cheese on the disk and leave the nails in for the first nights. When the bait is being taken, pull the nails out. Keep the bucket dry, and check it every morning.
Efni fyrir þetta skref:
Fata1 stykki
Krossviðarplata1 stykki
Trétappi1 stykki
Augaskrúfa2 stykki
Flöt skinna4 stykki
Tréskrúfur1 stykki
Naglar2 stykki
Band1 stykki
Flatt tréborð1 stykki
Ostur50 gNauðsynleg verkfæri:
Rottugildra
Laufsög
Hleðslubor
Borasett
Stafræn eldhúsvog
Reglustika
Merkipenni5
5
A platform that won't tip, won't return, or is ignored
A platform that won't tip, won't return, or is ignored
Tipping-platform troubleshooting.
Flow
Loading...
6
6
History and honest limits
History and honest limits
**Seaborn H. B. Harwell** of Morgan County, Georgia, filed US 290,580 on 26 July 1883; it is dated 18 December 1883. His vessel was "nearly filled with water" and the patent says the catch was drowned. It also shows a vessel shaped like a truncated cone, whose inward-sloping sides "would effectually prevent any climbing up and out". This rung builds it dry, to catch the animal alive.
**Honest limits.** The notebook treats the disk as rigid and the animal as standing still; a moving animal adds forces the notebook leaves out. Masses, depths and the grip angle are examples. Your weights on the disk are the measurement.
Efni
10- 1 stykkiStaðgengill
- 1 stykkiStaðgengill
- 1 stykkiStaðgengill
- 2 stykkiStaðgengill
- 4 stykkiStaðgengill
- 1 stykkiStaðgengill
- 2 stykkiStaðgengill
- 1 stykkiStaðgengill
- 1 stykkiStaðgengill
- 50 gStaðgengill
Nauðsynleg verkfæri
7- Staðgengill
- Staðgengill
- 1 vendor sell this, none ship to you yetStaðgengill
- Staðgengill
- Staðgengill
- Staðgengill
- Staðgengill
Tengd Blueprint
Þessi blueprint deila þekkingu — tækni, efni eða meginreglur
CC0 opinbert ríki
Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.
Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.


