LIST
FEGURÐ OG VELLÍÐAN
HANDVERK
MENNING OG SAGA
SKEMMTUN
UMHVERFI
MATUR OG DRYKKUR
ÖFUGVERKFRÆÐI
VÍSINDI
ÍÞRÓTTIR
TÆKNI
KLÆÐANLEG TÆKNI
Wool Cloth Woven in Plain Weave on a Rigid Heddle Loom
Tex

Búin til af

Tex

14. október 2026FO
5
0
0
0
0

Wool Cloth Woven in Plain Weave on a Rigid Heddle Loom

Plain weave is the most basic weave: each weft thread goes over one warp thread and under the next. Woven from undyed wool yarn, the cloth comes off the loom loose and soft, still oily and unshrunk; fulling cleans and thickens it afterwards. The picture: plain weave seen close up.
Byrjandi
A few days

Leiðbeiningar

1

Warp the loom

Measure the warp (step 5), tie it to the front roller, and thread one end through each slot and each hole of the heddle. Wind it on the back roller under even tension.

Efni fyrir þetta skref:

UppistöðugarnUppistöðugarn320 m

Nauðsynleg verkfæri:

Vefstóll með stífu skeiðiVefstóll með stífu skeiði
ReglustikaReglustika
C-þvingaC-þvinga
SkæriSkæri
2

Weave

Lift the heddle, pass the shuttle through, lower the heddle and pass it back, beating each pick in lightly with the heddle. Lay the weft in at a slant so the edges do not draw in.

Efni fyrir þetta skref:

ÍvafsgarnÍvafsgarn265 m

Nauðsynleg verkfæri:

Vefstóll með stífu skeiðiVefstóll með stífu skeiði
VefskyttaVefskytta
3

Advance and keep going

Wind the woven cloth onto the front roller as you go, keeping the beat even so the cloth has the same number of picks per cm all along.

Nauðsynleg verkfæri:

Vefstóll með stífu skeiðiVefstóll með stífu skeiði
ReglustikaReglustika
4

Cut off

Weave to the end of the warp, cut the cloth off, and knot the warp ends in groups so the weft cannot unravel. It is now loom-state cloth, ready for fulling.

Nauðsynleg verkfæri:

SkæriSkæri
5

Yarn for the cloth

Hleð Jupyter-vinnubók…

Efni

2

Nauðsynleg verkfæri

5

CC0 opinbert ríki

Þessi teikning er gefin út undir CC0. Þér er frjálst að afrita, breyta, dreifa og nota þetta verk í hvaða tilgangi sem er, án þess að biðja um leyfi.

Studdu smiðinn með því að kaupa vörur í gegnum teikningu hans þar sem hann fær þóknun smiða sem seljendur ákvarða, eða búðu til nýja endurskoðun á þessari teikningu og tengdu hana sem tengingu í þinni eigin teikningu til að deila tekjum.

Umræða

(0)

Skrá inn til að taka þátt í umræðunni

Hleður athugasemdum...