ARTE
BELLEZZA E BENESSERE
MESTIERE
CULTURA E STORIA
DIVERTIMENTO
AMBIENTE
CIBO E BEVANDE
INGEGNERIA INVERSA
SCIENZE
SPORT
TECNOLOGIA
INDOSSABILI
Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass
Charlie

Creato da

Charlie

24. settembre 2026DE
23
0
0
0
0

Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass

Boiling a solution dry gives you everything that was dissolved in it, including the impurities. Letting it crystallise slowly gives you the substance you wanted and leaves most of the impurities in the liquid — because a growing crystal is fussy about what it lets in. So evaporating to dryness and crystallising are not two ways of doing the same job. The first is for recovering everything; the second is for purifying. Then there is the question of when it is actually DRY, which cannot be answered by looking. The answer is a measurement loop: dry, weigh, dry again, weigh again, and stop when the mass stops changing.
Intermedio
3 hours

Istruzioni

1

Evaporate gently, and never to the last drop over heat

Use a wide, shallow evaporating dish rather than a beaker: evaporation happens at the surface, so the area is what sets the speed, and a wide dish is faster at a much lower temperature. Stop while a little liquid remains and let the rest go at room temperature. Once the liquid is nearly gone there is nothing left to absorb the heat, the solid overheats in seconds, and it spits, decomposes or bakes onto the dish. A steam bath or a hot plate on a low setting is better than a flame for anything that matters. Direct flame heats one spot far above the boiling point of the solution, and many substances that survive 100 degrees do not survive that.

Materiali per questo passaggio:

Acqua distillataAcqua distillata1 litro
Cloruro di sodio (sale)Cloruro di sodio (sale)1 pezzo

Strumenti necessari:

Capsula di evaporazioneCapsula di evaporazione
Piastra riscaldantePiastra riscaldante
Vetro da orologioVetro da orologio
2

Crystallise slowly, and crystallise on purpose

Dissolve the solid in the smallest volume of hot solvent that will take it, then let it cool UNDISTURBED. Slow cooling grows few, large, pure crystals; rapid cooling or stirring gives a mass of tiny ones that trap the mother liquor and everything dissolved in it. If nothing appears, it is usually because there is too much solvent or because there is no nucleus to start on. Boil a little solvent off, scratch the inside of the glass with a rod at the surface, or add one seed crystal. Then filter the crystals off cold and rinse them with a SMALL amount of ICE-COLD solvent. Rinsing with warm solvent dissolves the product you just spent an hour growing, which is the most disheartening way to lose a yield.

Materiali per questo passaggio:

Acqua distillataAcqua distillata1 litro
Solfato di rame pentaidrato (CuSO4·5H2O)Solfato di rame pentaidrato (CuSO4·5H2O)1 pezzo

Strumenti necessari:

Becher di vetroBecher di vetro
Bacchetta di vetroBacchetta di vetro
Imbuto di Büchner (porcellana)Imbuto di Büchner (porcellana)
Carta da filtroCarta da filtro
3

Dry to constant mass, which is a measurement not a judgement

Caricamento del notebook Jupyter…

Materiali per questo passaggio:

Cloruro di sodio (sale)Cloruro di sodio (sale)1 pezzo

Strumenti necessari:

EssiccatoioEssiccatoio
Essiccatore di vetroEssiccatore di vetro
Bilancia di precisioneBilancia di precisione
Computer da tavoloComputer da tavolo
4

Work out the yield, and be honest about it

Percentage yield is what you got divided by what the equation says you could have got. Both numbers have to be real: the mass actually recovered and dried, and the theoretical mass calculated from the LIMITING reagent. Yields above 100% mean the product is not dry, or it has picked up something. That is worth treating as a fault rather than a bonus, because a wet product weighs more and is worth less. Record where the losses went, in the notebook: left in the mother liquor, stuck to the filter paper, lost in the rinse, spilled. Those lines are what make the next attempt better, and a yield with no explanation attached is a number nobody can improve.

Strumenti necessari:

Bilancia di precisioneBilancia di precisione
CalcolatriceCalcolatrice

Materiali

3

Strumenti richiesti

12

CC0 Pubblico dominio

Questo progetto è rilasciato sotto CC0. Sei libero di copiare, modificare, distribuire e utilizzare quest'opera per qualsiasi scopo, senza chiedere permesso.

Supporta il Maker acquistando prodotti tramite il suo progetto dove guadagna una Commissione Maker stabilita dai venditori, oppure crea una nuova iterazione di questo progetto e includilo come collegamento nel tuo progetto per condividere i ricavi.

Commenti

(0)

Accedi per partecipare alla discussione

Caricamento commenti...