ARTE
BELLEZZA E BENESSERE
MESTIERE
CULTURA E STORIA
DIVERTIMENTO
AMBIENTE
CIBO E BEVANDE
INGEGNERIA INVERSA
SCIENZE
SPORT
TECNOLOGIA
INDOSSABILI
Sheet Metal Stamping: Blanks, Drawn Cans and Washers
Stamping turns coil into parts at press speed. The coil is uncoiled, straightened and fed into a press whose die cuts and shapes it: blanking cuts the outline, piercing punches holes, forming bends, drawing pulls a flat blank into a cup. A washer is one blank pierced in the middle. A drink can is a blank punched from stiff cold-rolled aluminium sheet (typically alloy 3104-H19 or 3004-H19), drawn into a cup about three inches across, then pushed through ironing rings that stretch and thin the wall. Its end is stamped separately from alloy 5182-H48 coil; a conversion press forms the rivet button, scores the opening and fits the tab.
Avanzato
Seconds per part (industrial)
Istruzioni
1
1
Uncoil and straighten
Uncoil and straighten
The coil is set on an uncoiler and fed through straightening rolls into the press.
Materiali per questo passaggio:
Bobina di alluminio100 kg
Bobina d'acciaio100 kg2
2
Blank and pierce
Blank and pierce
In a progressive die each press stroke advances the strip one station: one station pierces holes, the next blanks the outline. Steel washers are made this way.
Strumenti necessari:
Pressa per stampaggio
Stampo progressivo3
3
Draw cups
Draw cups
For cans, round blanks of aluminium are drawn into shallow cups.
Strumenti necessari:
Pressa per stampaggioStampo progressivo4
4
Redraw and iron
Redraw and iron
Each cup is pushed through ironing rings that lengthen and thin the wall; the base dome is formed at the same time.
Strumenti necessari:
Pressa per stampaggio5
5
Trim, neck and flange
Trim, neck and flange
The ragged top is trimmed and the open end necked in and flanged to take the end.
Strumenti necessari:
Pressa per stampaggio6
6
Stamp the ends
Stamp the ends
Shells are stamped from end-stock coil; a conversion press forms the rivet button, scores the opening and fits a tab formed from a separate strip.
Strumenti necessari:
Pressa per stampaggioStampo progressivo7
7
Inspect
Inspect
Parts are measured against the drawing; cans are checked for wall thickness and leaks.
Strumenti necessari:
Calibro digitale da 6 polliciMateriali
2- 100 kgSegnaposto
- 100 kgSegnaposto
Questo progetto realizza
Blueprint correlati
Questi blueprint condividono conoscenze — tecniche, materiali o principi
CC0 Pubblico dominio
Questo progetto è rilasciato sotto CC0. Sei libero di copiare, modificare, distribuire e utilizzare quest'opera per qualsiasi scopo, senza chiedere permesso.
Supporta il Maker acquistando prodotti tramite il suo progetto dove guadagna una Commissione Maker stabilita dai venditori, oppure crea una nuova iterazione di questo progetto e includilo come collegamento nel tuo progetto per condividere i ricavi.