Collaborazione
ARTE
BELLEZZA E BENESSERE
MESTIERE
CULTURA E STORIA
DIVERTIMENTO
AMBIENTE
CIBO E BEVANDE
INGEGNERIA INVERSA
SCIENZE
SPORT
TECNOLOGIA
INDOSSABILI
Sponge: Hooked and Crawl-Cured (Florida, Moore 1910)
Charlie

Creato da

Charlie

4. novembre 2026DE
7
0
0
0
0

Sponge: Hooked and Crawl-Cured (Florida, Moore 1910)

How Florida hookers took and cured bath sponges around 1900: sight the sponge through a glass-bottomed bucket from a two-man dingey, tear it loose with a three-tined hook on a pole, let it die on deck root down, rot it out for a week in a staked pen in salt water, then beat, squeeze and scrape it clean and string it in bunches. Maceration in fresh water darkens the fibre, so the pen stands in salt or brackish water. Source: H. F. Moore, The Commercial Sponges and the Sponge Fisheries (U.S. Bureau of Fisheries, 1910), pp. 436-453. Picture: Plate XXX, a Rock Island sheepswool sponge.
Intermedio
Unknown

Istruzioni

1

Build the crawl

On shore near the sponge grounds, in salt or brackish water, build a crawl (kraal) about 10 ft square: stakes driven close together and nailed to horizontal pieces to keep them from spreading.

Strumenti necessari:

Picchetto di legnoPicchetto di legno
Chiodi di ferroChiodi di ferro
MartelloMartello
2

Sight the sponges

Work two to a dingey: the sculler moves the boat on the hooker's signals; the hooker kneels in the waist, leaning over the side, watching the bottom through the water glass, a bucket whose glass bottom is held below the surface to cut out reflections. In clear water the bottom can be seen to about 50 ft.

Strumenti necessari:

Barca piccola di legnoBarca piccola di legno
Secchio con fondo di vetroSecchio con fondo di vetro
3

Hook them loose

When a sponge is sighted the sculler puts the boat in position. The hooker rests the pole on his shoulder as a fulcrum, lowers the hook with his right hand while holding the water glass with his left, sets the tines into the base of the sponge and tears it loose, taking care not to mutilate it.

Strumenti necessari:

Gancio per spugneGancio per spugne
Secchio con fondo di vetroSecchio con fondo di vetro
Barca piccola di legnoBarca piccola di legno
4

Kill them on deck

Lay the sponges on deck root down so the gurry, the liquefied matter from decomposition, can run out. In hot sun the inner tissues begin to slough in a day or two; in cold cloudy weather a week may not be enough. Keep the skin from drying and sticking to the skeleton.

Strumenti necessari:

Barca piccola di legnoBarca piccola di legno
5

Macerate, beat and squeeze

Put the dead sponges in the crawl for about a week to macerate. Then remove what flesh is left by beating each partly submerged sponge with a short heavy stick and squeezing it again and again under water. Scrape off any skin that sticks with a dull knife.

Strumenti necessari:

BastoneBastone
ColtelloColtello
6

String them in bunches

With a long needle string the cleaned sponges on rope yarns 6 ft long, sponges of about the same size together, eye and root (the top of one against the bottom of the next). Tie the ends of each yarn together into a wreath, a bunch, and partly dry them.

Strumenti necessari:

Ago a cruna grandeAgo a cruna grande
CordameCordame

Strumenti richiesti

10

Questo progetto realizza

CC0 Pubblico dominio

Questo progetto è rilasciato sotto CC0. Sei libero di copiare, modificare, distribuire e utilizzare quest'opera per qualsiasi scopo, senza chiedere permesso.

Supporta il Maker acquistando prodotti tramite il suo progetto dove guadagna una Commissione Maker stabilita dai venditori, oppure crea una nuova iterazione di questo progetto e includilo come collegamento nel tuo progetto per condividere i ricavi.

Commenti

(0)

Accedi per partecipare alla discussione

Caricamento commenti...