Ushirikiano
SANAA
UREMBO NA USTAWI
UJANJA
UTAMADUNI NA HISTORIA
BURUDANI
MAZINGIRA
CHAKULA NA VINYWAJI
UHANDISI WA KINYUME
SAYANSI
MICHEZO
TEKNOLOJIA
VAZI
Cane Glue Brush: the Bark Stripped from One End and the Fibres Hammered Loose (Adamson, Amateur Work, 1887)
Woody

Imeundwa na

Woody

14. Novemba 2026NO
4
0
0
0
0

Cane Glue Brush: the Bark Stripped from One End and the Fibres Hammered Loose (Adamson, Amateur Work, 1887)

The fret-cutter's glue brush recommended by D. B. Adamson in Amateur Work (1887): a piece of cane with the hard outer skin cut away at one end and the end hammered until the fibres loosen into a stiff brush, "better than any other" for rubbing glue into wood.
Mwanzo
A few minutes

Maagizo

1

Read Adamson

"Nothing is better than a piece of cane beaten out at one end."
2

Strip the end

Take a piece of cane (ours: about 15-20 cm) and cut off the hard outer covering for a short distance at one end (ours: about 2 cm).

Vifaa kwa hatua hii:

HenziraniHenzirani1 kipande

Zana zinazohitajika:

Kisu cha kaziKisu cha kazi
3

Beat out the fibres

Lay the stripped end on a hard surface and hammer it until the fibres loosen into a brush.

Zana zinazohitajika:

NyundoNyundo
4

Use it

Warm the glue by standing its can or bottle in a basin of hot water, then rub the glue well into the wood with the brush.

Vifaa kwa hatua hii:

MajiMaji1 kipande

Zana zinazohitajika:

NdooNdoo
GundiGundi
5

Troubleshooting

Cane brush troubleshooting.

Flow

Loading...
6

History and honest limits

From D. B. Adamson, "Fretsaw Work and Marquetry Cutting" III, **Amateur Work, Illustrated**, vol. VII (1887), p. 230 (checked on the archive.org scan amateurworkillus71887lond). He gives no lengths: those and the knife are ours.

Vifaa

2
  • 1 kipande
    Kishikilia Nafasi
  • 1 kipande
    Kishikilia Nafasi

Zana Zinazohitajika

4
  • Kishikilia Nafasi
  • Kishikilia Nafasi
  • Kishikilia Nafasi
  • Kishikilia Nafasi

CC0 Umma Wote

Mchoro huu umetolewa chini ya CC0. Uko huru kunakili, kubadilisha, kusambaza, na kutumia kazi hii kwa madhumuni yoyote, bila kuomba ruhusa.

Saidia Mtengenezaji kwa kununua bidhaa kupitia Mchoro wao ambapo wanapata Kamisheni ya Mtengenezaji iliyowekwa na Wachuuzi, au unda marudio mapya ya Mchoro huu na uiunganishe kama kiungo katika Mchoro wako kuchangia mapato.

Majadiliano

(0)

Ingia kujiunga na majadiliano

Inapakia maoni...