SANAA
UREMBO NA USTAWI
UJANJA
UTAMADUNI NA HISTORIA
BURUDANI
MAZINGIRA
CHAKULA NA VINYWAJI
UHANDISI WA KINYUME
SAYANSI
MICHEZO
TEKNOLOJIA
VAZI
Horseshoe Nails Forged and Headed from Iron Rod
Forge

Imeundwa na

Forge

14. Oktoba 2026NO
14
0
0
0
0

Horseshoe Nails Forged and Headed from Iron Rod

Horseshoe nails hold the shoe through the hard outer wall of the hoof. They are shaped to bend outward as they are driven, so the point comes out through the wall, where it is cut off and clinched over. A shoe complete with its nails was found in a fifth-century grave. Draw a flat tapering shank, bevel the point on one side, and head it. The picture: horseshoe nails in three sizes.
Kati
Half a day

Maagizo

1

Draw the shank

Heat the end of the rod and draw a flat, tapering shank about 45 mm long, thinner toward the point.

Vifaa kwa hatua hii:

Fito ya chuma cha kufuaFito ya chuma cha kufua2 m

Zana zinazohitajika:

Fua ya mhunziFua ya mhunzi
FuaweFuawe
Nyundo yenye kichwa cha msalabaNyundo yenye kichwa cha msalaba
Koleo za mhunziKoleo za mhunzi
Glavu za kulehemuGlavu za kulehemu
Miwani ya usalamaMiwani ya usalama
2

Bevel the point

Forge a short bevel on one face of the point only. Mark that face: it goes toward the inside of the hoof, so the nail turns outward.

Zana zinazohitajika:

FuaweFuawe
Nyundo yenye kichwa cha msalabaNyundo yenye kichwa cha msalaba
Koleo za mhunziKoleo za mhunzi
Glavu za kulehemuGlavu za kulehemu
Miwani ya usalamaMiwani ya usalama
3

Cut and head

Nick the rod on the hardy a little above the shank, drop the shank into the header, snap it off and hammer the stub into a tapered, wedge-shaped head that will sit in the nail hole of the shoe.

Zana zinazohitajika:

Fua ya mhunziFua ya mhunzi
Patasi ya kukata kwenye fuawePatasi ya kukata kwenye fuawe
Kibamba cha kutengeneza vichwa vya misumariKibamba cha kutengeneza vichwa vya misumari
Nyundo yenye kichwa cha msalabaNyundo yenye kichwa cha msalaba
Koleo za mhunziKoleo za mhunzi
Glavu za kulehemuGlavu za kulehemu
Miwani ya usalamaMiwani ya usalama
4

Finish

Let them cool in air so the iron stays soft enough to clinch. File off any burr and check each one is straight.

Zana zinazohitajika:

Tupa ya chumaTupa ya chuma
5

Nails for a set

Inapakia daftari la Jupyter…

Vifaa

1

Zana Zinazohitajika

9

CC0 Umma Wote

Mchoro huu umetolewa chini ya CC0. Uko huru kunakili, kubadilisha, kusambaza, na kutumia kazi hii kwa madhumuni yoyote, bila kuomba ruhusa.

Saidia Mtengenezaji kwa kununua bidhaa kupitia Mchoro wao ambapo wanapata Kamisheni ya Mtengenezaji iliyowekwa na Wachuuzi, au unda marudio mapya ya Mchoro huu na uiunganishe kama kiungo katika Mchoro wako kuchangia mapato.

Majadiliano

(0)

Ingia kujiunga na majadiliano

Inapakia maoni...