SANAA
UREMBO NA USTAWI
UJANJA
UTAMADUNI NA HISTORIA
BURUDANI
MAZINGIRA
CHAKULA NA VINYWAJI
UHANDISI WA KINYUME
SAYANSI
MICHEZO
TEKNOLOJIA
VAZI
Small Wooden Wheels: Cut with a Hole Saw, Bored for the Axle
Small wheels for models and toys that run on a dowel axle. A hole saw cuts each wheel as a round disc, and its pilot drill leaves a hole at the exact centre, which is opened up so the wheel turns freely on the axle. Sizes are ours.
The picture: our drawing.
Mwanzo
1 hour
Maagizo
1
1
Cut the discs
Cut the discs
Clamp an 18 mm hardwood board on the drill press table over scrap and cut 50 mm discs with the hole saw at slow speed, half way from each side so the edges do not splinter.
Vifaa kwa hatua hii:
Ubao wa Mti Mgumu1 kipandeZana zinazohitajika:
Kekee cha Nguzo
Seti ya misumeno ya duara
Miwani ya usalama2
2
Bore the axle hole
Bore the axle hole
Open the pilot hole with a drill a little larger than the 8 mm dowel axle, square to the face, so the wheel runs without wobble.
Zana zinazohitajika:
Kekee cha Nguzo
Seti ya vichimbuzi
Kipima-unene cha dijitali cha inchi 63
3
Sand and oil
Sand and oil
Sand the rims and faces smooth, round the edges slightly, and wipe on a thin coat of linseed oil.
Vifaa kwa hatua hii:
Mafuta ya Kitani20 mlZana zinazohitajika:
Mkusanyo wa sandarusi
Matambara ya pambaVifaa
2- 1 kipandeKishikilia Nafasi
- 20 mlKishikilia Nafasi
Zana Zinazohitajika
7- Kishikilia Nafasi
- Kishikilia Nafasi
- Kishikilia Nafasi
- Kishikilia Nafasi
- Kishikilia Nafasi
- Kishikilia Nafasi
- Kishikilia Nafasi
Mchoro huu unatengeneza
Blueprint zinazohusiana
Blueprint hizi zinashiriki maarifa — mbinu, vifaa au kanuni
CC0 Umma Wote
Mchoro huu umetolewa chini ya CC0. Uko huru kunakili, kubadilisha, kusambaza, na kutumia kazi hii kwa madhumuni yoyote, bila kuomba ruhusa.
Saidia Mtengenezaji kwa kununua bidhaa kupitia Mchoro wao ambapo wanapata Kamisheni ya Mtengenezaji iliyowekwa na Wachuuzi, au unda marudio mapya ya Mchoro huu na uiunganishe kama kiungo katika Mchoro wako kuchangia mapato.