Ushirikiano
SANAA
UREMBO NA USTAWI
UJANJA
UTAMADUNI NA HISTORIA
BURUDANI
MAZINGIRA
CHAKULA NA VINYWAJI
UHANDISI WA KINYUME
SAYANSI
MICHEZO
TEKNOLOJIA
VAZI
Wedging Table: Plaster-Topped with a Cutting Wire (Binns, 1910)
The potter's wedging table Binns taught: a strong table with a 30 by 20 in top of two-inch plank, edged to make a trough filled with plaster, and a fine brass wire stretched diagonally from a post on one side for cutting the clay.
Clay is cut on the wire and slapped down on the plaster, fifteen or twenty times, until it is even; wet the plaster if it stiffens the clay too fast.
Source: C. F. Binns, The Potter's Craft (1910), p. 79. Picture: the book's text.
Mwanzo
Unknown
Maagizo
1
1
Make the top
Make the top
Build a strong table whose top, about 30 by 20 in, is of two-inch plank. Nail a raised edge 2 in high firmly to the sides to form a trough.
Vifaa kwa hatua hii:
Ubao wa mbao1 two-inch plank, about 30 x 20 in
Ubao1 raised edge, 2 in high
Misumari ya Chuma1 kipandeZana zinazohitajika:
Msumeno wa mkono
Nyundo2
2
Pour the plaster
Pour the plaster
Fill the trough with plaster and let it harden.
Vifaa kwa hatua hii:
Plasta ya Paris1 kipandeZana zinazohitajika:
Nyundo3
3
Fit the post and wire
Fit the post and wire
Fasten an upright post in the centre of one side and stretch a fine brass wire from its top to the other side of the table, making a diagonal. The worker stands on the side opposite the post.
Vifaa kwa hatua hii:
Nyenzo isiyojulikana1 upright post, material not given
Waya mwembamba wa shaba nyeusi1 fine brass wireMisumari ya Chuma1 kipandeZana zinazohitajika:
NyundoMsumeno wa mkonoVifaa
6- 1 two-inch plank, about 30 x 20 inKishikilia Nafasi
- 1 raised edge, 2 in highKishikilia Nafasi
- 2 vipandeKishikilia Nafasi
- 1 kipandeKishikilia Nafasi
- 1 upright post, material not givenKishikilia Nafasi
- 1 fine brass wireKishikilia Nafasi
Mchoro huu unatengeneza
CC0 Umma Wote
Mchoro huu umetolewa chini ya CC0. Uko huru kunakili, kubadilisha, kusambaza, na kutumia kazi hii kwa madhumuni yoyote, bila kuomba ruhusa.
Saidia Mtengenezaji kwa kununua bidhaa kupitia Mchoro wao ambapo wanapata Kamisheni ya Mtengenezaji iliyowekwa na Wachuuzi, au unda marudio mapya ya Mchoro huu na uiunganishe kama kiungo katika Mchoro wako kuchangia mapato.