예술

뷰티 및 웰니스

공예

문화 및 역사

엔터테인먼트

환경

음식 및 음료

역공학

과학

스포츠

기술

웨어러블

BenFrantzDale (Wikimedia Commons) · CC BY-SA 4.0

작성자

Woody

11. 10월 2026

Pine Boards with a Chainsaw Mill

A chainsaw mill is a frame that holds the saw's bar flat at a set height, so the chain rips a log lengthways into boards. The first cut rides on a straight board screwed to the log; every later cut rides on the flat face before it. The green boards are then stacked on stickers to air-dry. Pine dries fast: a 25 mm board can reach about 14 % moisture in 60 to 90 days in good drying weather. Oak and other slow species take far longer.

중급

1 day milling, 2–3 months drying

안내

Pick and prop the log

Choose a straight pine log, 2.5–3 m long, without large knots. Prop it on two short logs so it cannot roll and the chain will not reach the ground.

이 단계의 재료:

침엽수 통나무1 개

필요한 도구:

줄자

Fit the mill

Bolt the mill to the chainsaw bar following its maker's instructions. A ripping chain cuts along the grain faster and smoother than a crosscut chain.

필요한 도구:

체인톱(전문 임업용)

체인톱 제재기

Screw on the guide board

Screw a straight board along the top of the log, level from end to end, as the rail for the first cut. Check it with the straightedge and level.

이 단계의 재료:

나사못6 개

필요한 도구:

소나무 판재

무선 드릴

직각 자

수평계

First cut

Wearing helmet with visor, ear protection, gloves and boots, run the mill along the guide board and take off the top slab. Remove the guide board.

필요한 도구:

체인톱(전문 임업용)

체인톱 제재기

안전모

귀 보호 덮개

가죽 작업 장갑

강철 앞심 안전화

Cut the boards

Set the mill a few millimetres thicker than the finished board, to allow for shrinking and planing. Run each cut on the flat face left by the one before.

필요한 도구:

체인톱(전문 임업용)

체인톱 제재기

줄자

Seal the ends

Paint both ends of every board with end sealer the same day, to stop them splitting as they dry.

이 단계의 재료:

마구리 막이 (파라핀 밀랍)0.5 리터

Sticker the stack

On a level base at least 30 cm off the ground, lay the boards in layers with a gap between them, each layer on stickers every 40–60 cm, the stickers one above the other.

이 단계의 재료:

굄목 (건조용 간격재)30 개

필요한 도구:

나무 팔레트

수평계

Cover and weight

Cover the top of the stack against rain and lay weight on it to keep the top boards flat; leave the sides open to the air.

필요한 도구:

방수 천막

Measure the moisture

After 2 months, read a board from the middle of the stack. Air-dry outdoors reaches about 12–15 %; bring boards for furniture indoors to settle at 6–8 % before working them.

필요한 도구: