Gasholder: Water-Sealed Zinc Gasometer with Balance Weights (Ramsay & Travers, 1898)

The laboratory gasometer Ramsay and Travers used to store argon: a zinc bell that rises and falls in a narrow ring of water between two fixed zinc cylinders. Because the water space is only about 2 cm wide, little gas dissolves in it. Weights on cords over pulleys balance the bell, and weights laid on top push the gas out. Result: a water-sealed gasholder of 18 to 180 litres. Source: M. W. Travers, The Experimental Study of Gases (1901), pp. 30 and 105-106. Unknown: sizes and how the zinc is joined. Picture: Fig. 34, the small mercury form of the same design.

중급

Unknown

안내

Make the fixed cylinders

Make two concentric zinc cylinders on a closed base, leaving a ring-shaped space about 2 cm wide between them for the water. Make the top of the inner cylinder dome-shaped. Bring a gas pipe with a stopcock up through the inner cylinder. Ours: zinc soldered with tin-lead solder. Not given: sizes, how the zinc is joined, the stopcock.

이 단계의 재료:

아연판1 outer and inner cylinders, base

주석-납 땜납1 seams

미상의 밸브1 gas stopcock

필요한 도구:

판금 가위

인두

미상의 성형 방법

알 수 없는 치수

Make and hang the bell

Make the gasholder bell of zinc to fit closely over the inner cylinder and down into the water ring, with a dome-shaped top matching the inner cylinder's, so all the gas can be pushed out. Ramsay and Travers made bells of about 180, 27, 18 and 18 litres. Tie a cord to the top of the bell and pass it over pulleys to a hanging weight, to take the bell's own weight off the gas. Fill the ring with water. To deliver gas, take weight off the cord or lay weights on top of the bell. Not given: the weights.

이 단계의 재료:

아연판1 bell

주석-납 땜납1 seams