සහයෝගීතාව
කලාව
රූපලාවණ්ය සහ සුවතාව
ශිල්පය
සංස්කෘතිය සහ ඉතිහාසය
විනෝදාස්වාදය
පරිසරය
ආහාර සහ පාන
ප්රතිලෝම ඉංජිනේරු
විද්යාවන්
ක්රීඩා
තාක්ෂණය
පැළඳිය හැකි

Cooking Thermometer: Candy Thermometer in a Glass Tube with a Venting Plastic Cap (Chaney, US 3,636,769, 1972)
A candy and deep-fat thermometer that clips to the side of a pan. A glass thermometer on a printed scale card sits inside a protective glass tube, so it never touches the candy. The top of the tube is closed by a polyethylene cap that seals in normal use but softens when the whole thermometer is heated far too hot, as in an oven, so the air inside escapes instead of bursting the tube.
Result: a pan-side cooking thermometer that cannot explode if overheated.
Source: J. L. Chaney, US 3,636,769 (1972). Unknown: the scale range, sizes and several materials. Picture: the patent drawing.
මධ්යම
Unknown
උපදෙස්
1
1
Mount the thermometer on its scale
Mount the thermometer on its scale
Fasten a glass thermometer tube to a graduated scale card with small fasteners, the bulb at the bottom. The patent's card is marked with cooking points such as soft ball, hard ball, soft crack, hard crack, fish, fowl, potatoes and doughnuts. Fix a disk on top of the card to keep it centred in the outer tube. Not given: the range, the card and fastener materials.
මෙම පියවර සඳහා ද්රව්ය:
රසායනාගාර උෂ්ණත්වමානය1 thermometer tube
නොදන්නා ද්රව්යය1 scale card, disk
නොදන්නා ලෝහය1 fastenersඅවශ්ය මෙවලම්:
නොදන්නා මිනුම්2
2
Enclose it in the protective tube
Enclose it in the protective tube
Slide the card and thermometer into a glass protective tube, open at the top, so the bulb reaches the lower end and touches a metal cap there to pass on the heat. Not given: the tube size, the metal of the end cap, how the cap is joined to the tube.
මෙම පියවර සඳහා ද්රව්ය:
වීදුරු නළය1 protective tube
නොදන්නා ලෝහය1 end capඅවශ්ය මෙවලම්:
නොදන්නා මිනුම්3
3
Fit the venting cap
Fit the venting cap
Close the open top with a cup-shaped cap of a thermoplastic such as polyethylene, a friction fit that seals out dirt. Polyethylene softens at about 180 °F and melts near 250 °F: if the thermometer is heated in an oven to 400-550 °F, the air inside would reach 12-14 psi, but the cap distorts first and lets it out. Do not use rubber or a thermosetting plastic, which does not vent. Ours: LDPE.
මෙම පියවර සඳහා ද්රව්ය:
LDPE පෙති1 capඅවශ්ය මෙවලම්:
නොදන්නා මිනුම්4
4
Fit the pan clip and use it
Fit the pan clip and use it
Slide a spring clip onto the outside of the tube; its spring arm holds the thermometer upright over the edge of the pan. Clip it on with the bulb end in the candy or fat and read the scale; it also serves for deep frying. Ours: spring steel wire.
මෙම පියවර සඳහා ද්රව්ය:
පෙන වානේ කම්බිය1 clipඅවශ්ය මෙවලම්:
වටකුරු තුඩු අඬුවද්රව්ය
6- 1 thermometer tubeස්ථානගත
- 1 scale card, diskස්ථානගත
- 1 end capස්ථානගත
- 1 protective tubeස්ථානගත
- 1 capස්ථානගත
- 1 clipස්ථානගත
අවශ්ය මෙවලම්
2- ස්ථානගත
- ස්ථානගත
සම්බන්ධිත සැලසුම්වල ද්රව්ය

අනතුරුදායක
10% ආරෝපණය
Liquid-in-Glass Thermometer: Bulb, Fill, Seal and Scale
Penny විසින්
වීදුරු වැඩ
39
0
0
0
1
0

අනතුරුදායක
10% ආරෝපණය
LDPE Pellets: Ethylene Polymerised at 1500 Atmospheres with a Trace of Oxygen
Charlie විසින්
කාර්මික
12
0
0
0
2
0

10% ආරෝපණය
Spring Steel Strip and Wire, Hardened and Tempered
Forge විසින්
ලෝහ වැඩ
47
0
0
0
5
0
මෙම සැලසුම සාදන්නේ
CC0 පොදු වසම
මෙම බ්ලූප්රින්ට් CC0 යටතේ නිකුත් කර ඇත. ඔබට අවසර නොමැතිව පිටපත් කිරීම, වෙනස් කිරීම, බෙදා හැරීම සහ භාවිතා කිරීම කළ හැක.
බ්ලූප්රින්ට් හරහා නිෂ්පාදන මිලදී ගැනීමෙන් නිර්මාතෘට සහාය වන්න නිර්මාතෘ කොමිසම විකුණුම්කරුවන් විසින් නියම කළ, හෝ මෙම බ්ලූප්රින්ට්හි නව අනුවාදයක් සාදා ආදායම බෙදා ගැනීමට ඔබේ බ්ලූප්රින්ට්හි සම්බන්ධතාවයක් ලෙස ඇතුළත් කරන්න.
