සහයෝගීතාව
කලාව
රූපලාවණ්‍ය සහ සුවතාව
ශිල්පය
සංස්කෘතිය සහ ඉතිහාසය
විනෝදාස්වාදය
පරිසරය
ආහාර සහ පාන
ප්‍රතිලෝම ඉංජිනේරු
විද්‍යාවන්
ක්‍රීඩා
තාක්ෂණය
පැළඳිය හැකි
Platinum Crucible: Shaped from Foil in a Hollow in a Board (Morfit, 1849)
Charlie

නිර්මාතෘ

Charlie

7. නොවැම්බර් 2026DE
4
0
0
0
0

Platinum Crucible: Shaped from Foil in a Hollow in a Board (Morfit, 1849)

A small platinum crucible for igniting precipitates at high heat. Campbell Morfit (1849): "The experimenter himself can in any emergency readily form a crucible out of platinum foil by shaping it with the thumb or a small hammer, in a hemispherical cavity made in a board for the purpose." Platinum crucibles must be of pure metal and hammered, not turned; thin enough to weigh on a delicate balance. Foil thickness and the size of the hollow are not given. Source: C. Morfit, Chemical and Pharmaceutic Manipulations (1849), pp. 196-197. Picture: Fig. 164.
ආරම්භක
Unknown

උපදෙස්

1

Read Morfit

"The experimenter himself can in any emergency readily form a crucible out of platinum foil by shaping it with the thumb or a small hammer, in a hemispherical cavity made in a board for the purpose."
2

Make the hollow

Cut a hemispherical cavity in a board, the size of the crucible wanted. Morfit's crucibles hold from a fluidrachm to three fluid ounces; a half-ounce one is the most needed in analysis. How the cavity is cut is not given (ours: a gouge in a hardwood board).

අවශ්‍ය මෙවලම්:

දෘඪ දැව පුවරුවදෘඪ දැව පුවරුව
වක්‍ර නියනවක්‍ර නියන
නොදන්නා මිනුම්නොදන්නා මිනුම්
3

Shape the foil

Lay a piece of pure platinum foil over the hollow and press it in with the thumb, or work it in with a small hammer, until it takes the hemispherical shape. The foil thickness, and how the foil is made, are not given (unknown).

මෙම පියවර සඳහා ද්‍රව්‍ය:

ප්ලැටිනම්ප්ලැටිනම්1 foil

අවශ්‍ය මෙවලම්:

දෘඪ දැව පුවරුවදෘඪ දැව පුවරුව
රවුම් හිසක් සහිත මිටියරවුම් හිසක් සහිත මිටිය
නොදන්නා හැඩගැන්වීමේ ක්‍රමයනොදන්නා හැඩගැන්වීමේ ක්‍රමය
4

Care of the crucible

Blisters and flaws that appear after use come from impure metal and bad workmanship; remove them by the force of a small hammer. Loosen salts with boiling water and rub off stains with sand or pumice stone. Do not use sharp pointed instruments on it.

අවශ්‍ය මෙවලම්:

රවුම් හිසක් සහිත මිටියරවුම් හිසක් සහිත මිටිය

ද්‍රව්‍ය

1
  • ස්ථානගත

අවශ්‍ය මෙවලම්

5

මෙම සැලසුම සාදන්නේ

CC0 පොදු වසම

මෙම බ්ලූප්‍රින්ට් CC0 යටතේ නිකුත් කර ඇත. ඔබට අවසර නොමැතිව පිටපත් කිරීම, වෙනස් කිරීම, බෙදා හැරීම සහ භාවිතා කිරීම කළ හැක.

බ්ලූප්‍රින්ට් හරහා නිෂ්පාදන මිලදී ගැනීමෙන් නිර්මාතෘට සහාය වන්න නිර්මාතෘ කොමිසම විකුණුම්කරුවන් විසින් නියම කළ, හෝ මෙම බ්ලූප්‍රින්ට්හි නව අනුවාදයක් සාදා ආදායම බෙදා ගැනීමට ඔබේ බ්ලූප්‍රින්ට්හි සම්බන්ධතාවයක් ලෙස ඇතුළත් කරන්න.

සාකච්ඡාව

(0)

පිවිසෙන්න සාකච්ඡාවට එක්වීමට

අදහස් පූරණය කරමින්...