සහයෝගීතාව
කලාව
රූපලාවණ්‍ය සහ සුවතාව
ශිල්පය
සංස්කෘතිය සහ ඉතිහාසය
විනෝදාස්වාදය
පරිසරය
ආහාර සහ පාන
ප්‍රතිලෝම ඉංජිනේරු
විද්‍යාවන්
ක්‍රීඩා
තාක්ෂණය
පැළඳිය හැකි
Propane from Natural Gas: Oil Absorption, then Fractional Condensation under Pressure (Garner and Cooper, US 1,307,353)
Charlie

නිර්මාතෘ

Charlie

4. නොවැම්බර් 2026DE
3
0
0
0
0

Propane from Natural Gas: Oil Absorption, then Fractional Condensation under Pressure (Garner and Cooper, US 1,307,353)

A liquefied fuel gas must be one pure substance: a mixture gives a changing pressure and heating value as the flask empties. James B. Garner and Howell C. Cooper of the Hope Natural Gas Company (filed 1916, US 1,307,353) took the light gases out of natural gas with an absorbing oil, freed them from the gasoline, scrubbed out the last heavier vapours, and then split the butane-propane mixture by pressure alone: pumped into a long sloping pipe, the butane liquefied first and was drawn off; the propane left behind was compressed with water until it liquefied too. Not given: sizes (beyond their field pipe), flow rates and the absorber pressure. Source: J. B. Garner and H. C. Cooper, US 1,307,353 (1919). Picture: their three drawing sheets.
උසස්
Continuous (industrial)

උපදෙස්

1

Read US 1,307,353

"We continue to pump into this compression-chamber quantities of the gas to be reduced until, in consequence of increasing pressure, a liquefaction has taken place. ... this initial liquefaction is a liquefaction of the butane component alone, the propane component remaining at this pressure a gas."
2

Absorb the light vapours

Compress the natural gas from the wells, cool it, and bubble it through perforated pipes in two absorbers of absorbing oil (a petroleum hydrocarbon of 28 to 55 degrees Baume at 60 F), the oil flowing through them against the gas. The gas that is not absorbed goes on to the gas line.

මෙම පියවර සඳහා ද්‍රව්‍ය:

ස්වාභාවික වායුවස්වාභාවික වායුව1 continuous feed
නොදන්නා ද්‍රව්‍යයනොදන්නා ද්‍රව්‍යය1 as required

අවශ්‍ය මෙවලම්:

ගෑස් සම්පීඩකයගෑස් සම්පීඩකය
තාප හුවමාරුවතාප හුවමාරුව
වායු අවශෝෂකයවායු අවශෝෂකය
3

Drive off the light gases

Run the enriched oil through a liquid trap into a primary still heated by steam pipes, at about the absorbers' pressure and a low temperature, about 95 to 110 F. Only the constituents that are gases at ordinary pressure and temperature, butane and propane among them, distil off.

අවශ්‍ය මෙවලම්:

වාෂ්ප ආසවනයවාෂ්ප ආසවනය
හුමාල බොයිලේරුවහුමාල බොයිලේරුව
4

Take out the gasoline

Pass the oil through a reducing valve and a heat exchanger into a second steam still at lower pressure and higher temperature. The gasoline (pentane to octane) distils over and condenses in cooled coils into closed storage tanks; the butane and propane stay as gas above it.

අවශ්‍ය මෙවලම්:

වාෂ්ප ආසවනයවාෂ්ප ආසවනය
තාප හුවමාරුවතාප හුවමාරුව
කන්ඩෙන්සරයේ කුණ්ඩලයකන්ඩෙන්සරයේ කුණ්ඩලය
තෙල් ගබඩා ටැංකියතෙල් ගබඩා ටැංකිය
5

Scrub the butane and propane

Bubble the remaining gas through supplemental absorbers of "sun spirits" (a paraffin hydrocarbon of about 33.7 degrees Baume at 60 F), at about atmospheric pressure. They hold back any pentane or heavier vapour, and a mixture of nearly pure butane and propane comes off.

මෙම පියවර සඳහා ද්‍රව්‍ය:

නොදන්නා ද්‍රව්‍යයනොදන්නා ද්‍රව්‍යය1 as required

අවශ්‍ය මෙවලම්:

වායු අවශෝෂකයවායු අවශෝෂකය
6

Liquefy the butane

Pump the mixture, with rising pressure, into a long strong pipe laid up a slope (in the field theirs was a 5-inch pipe 125 feet long), opening its pet cocks now and then to find liquid. With their mixture (butane and propane in about equal weights) the butane alone liquefied at about 130 lb per square inch and was drawn off from the lower end into a tank.

අවශ්‍ය මෙවලම්:

ද්‍රවකරණ කුටීරයද්‍රවකරණ කුටීරය
ගෑස් සම්පීඩකයගෑස් සම්පීඩකය
පීඩන මානයපීඩන මානය
පීඩන වායු සිලින්ඩරයපීඩන වායු සිලින්ඩරය
ආරක්ෂිත කණ්ණාඩිආරක්ෂිත කණ්ණාඩි
7

Liquefy the propane

Close the inlet and force water into the lower end of the chamber. The rising water compresses the propane left in the upper end; the patent says it liquefied at about 650 lb per square inch. Open the outlet at the top and let the water drive the liquid propane through a cooler into a pressure cylinder, until the water shows at the top pet cock.

මෙම පියවර සඳහා ද්‍රව්‍ය:

ජලයජලය1 as required

අවශ්‍ය මෙවලම්:

තෙරපුම් පොම්පයතෙරපුම් පොම්පය
ද්‍රවකරණ කුටීරයද්‍රවකරණ කුටීරය
තාප හුවමාරුවතාප හුවමාරුව
පීඩන වායු සිලින්ඩරයපීඩන වායු සිලින්ඩරය
පීඩන මානයපීඩන මානය
8

The patent drawings

US 1,307,353, sheets 1-3: compressor, cooler and absorbers with the primary still (Fig. 1), the gasoline still, condensing coils, storage tanks and supplemental absorbers (Fig. 2), and the compression chamber with its pet cocks, gauge and the butane and propane tanks (Fig. 3). Public domain (expired patent).
9

History and honest limits

Garner and Cooper filed on 5 August 1916 for the Hope Natural Gas Company of Pittsburgh; the patent was granted on 24 June 1919. They wrote that butane and propane could not be separated by compressing the natural gas itself, only after the light pair had been isolated. The pressures (about 130 lb and about 650 lb) are those the patent reports for its own equal-weight mixture at field temperature; they say other proportions or temperatures change them. The absorbing oil and the sun spirits are given only by kind and gravity (unknown). Propane and butane are flammable gases held under pressure.

ද්‍රව්‍ය

3

අවශ්‍ය මෙවලම්

12

මෙම සැලසුම සාදන්නේ

CC0 පොදු වසම

මෙම බ්ලූප්‍රින්ට් CC0 යටතේ නිකුත් කර ඇත. ඔබට අවසර නොමැතිව පිටපත් කිරීම, වෙනස් කිරීම, බෙදා හැරීම සහ භාවිතා කිරීම කළ හැක.

බ්ලූප්‍රින්ට් හරහා නිෂ්පාදන මිලදී ගැනීමෙන් නිර්මාතෘට සහාය වන්න නිර්මාතෘ කොමිසම විකුණුම්කරුවන් විසින් නියම කළ, හෝ මෙම බ්ලූප්‍රින්ට්හි නව අනුවාදයක් සාදා ආදායම බෙදා ගැනීමට ඔබේ බ්ලූප්‍රින්ට්හි සම්බන්ධතාවයක් ලෙස ඇතුළත් කරන්න.

සාකච්ඡාව

(0)

පිවිසෙන්න සාකච්ඡාවට එක්වීමට

අදහස් පූරණය කරමින්...