සහයෝගීතාව
කලාව
රූපලාවණ්‍ය සහ සුවතාව
ශිල්පය
සංස්කෘතිය සහ ඉතිහාසය
විනෝදාස්වාදය
පරිසරය
ආහාර සහ පාන
ප්‍රතිලෝම ඉංජිනේරු
විද්‍යාවන්
ක්‍රීඩා
තාක්ෂණය
පැළඳිය හැකි
Siphon Tube: Glass Tube Bent with Drawn-Down Ends (Faraday, 1830)
Charlie

නිර්මාතෘ

Charlie

7. නොවැම්බර් 2026DE
2
0
0
0
0

Siphon Tube: Glass Tube Bent with Drawn-Down Ends (Faraday, 1830)

A glass siphon for drawing clear liquid off a settled deposit, which Michael Faraday (1830) rated far better than pouring. He bends a glass tube about 0.3 inch inside and 22 inches long so that one leg is about 2 inches longer than the other, and draws both ends down to about 0.2 inch. The narrow ends hold the liquid in while one end is closed with a finger; the wide body lets it run fast. Source: M. Faraday, Chemical Manipulation (1830), §550, pp. 241-242. Picture: his text and figure.
මධ්‍යම
Unknown

උපදෙස්

1

Read Faraday

"Let a piece of glass tube, about 0.3 of an inch internal diameter, 22 inches in length, and of sufficient thickness to bear ordinary laboratory work, be bent at the blow-pipe table, so that one limb shall be about two inches longer than the other; the extremities should be contracted at the lamp, until about 0.2 of an inch in diameter."
2

Cut the tube

Take glass tube about 0.3 in. inside diameter, thick enough for ordinary laboratory work, and cut 22 in. off it: make a deep mark round it with the edge of a sharp three-square file, then break it like a stick, pulling the hands slightly apart (§1152). Wall thickness in figures is not given (unknown).

මෙම පියවර සඳහා ද්‍රව්‍ය:

වීදුරු නළයවීදුරු නළය1 22 in.

අවශ්‍ය මෙවලම්:

කියතුරු (අත් කියතුර)කියතුරු (අත් කියතුර)
3

Bend it

Bend the tube in the flame of the blow-pipe table so that one leg is about 2 in. longer than the other. For so sharp a bend, do not bend it all at one spot: heat and bend one part as far as it will go without narrowing the bore, then heat the next part and carry the curve on until the legs are close (§1160).

අවශ්‍ය මෙවලම්:

මේස වීදුරු පිඹීමේ පන්දමමේස වීදුරු පිඹීමේ පන්දම
4

Draw down the ends

Heat each end and pull it along its length so that it lengthens and narrows (§1166), until the opening is about 0.2 in. across.

අවශ්‍ය මෙවලම්:

මේස වීදුරු පිඹීමේ පන්දමමේස වීදුරු පිඹීමේ පන්දම
5

Use it

Hold the siphon upside down with the short leg higher, fill it with water from Faraday's dropping-bottle (a wash bottle does the same job), holding its beak against the side of the opening so no air bubbles are caught; close the long leg with a finger and fill the short leg too. Turn it over, put the short leg into the liquid and lift the finger: the clear liquid runs out. A finger on the outer end slows or stops it; keep the inner end clear of the deposit (§§550-551).

අවශ්‍ය මෙවලම්:

සෝදන බෝතලයසෝදන බෝතලය

ද්‍රව්‍ය

1
  • ස්ථානගත

අවශ්‍ය මෙවලම්

3

මෙම සැලසුම සාදන්නේ

CC0 පොදු වසම

මෙම බ්ලූප්‍රින්ට් CC0 යටතේ නිකුත් කර ඇත. ඔබට අවසර නොමැතිව පිටපත් කිරීම, වෙනස් කිරීම, බෙදා හැරීම සහ භාවිතා කිරීම කළ හැක.

බ්ලූප්‍රින්ට් හරහා නිෂ්පාදන මිලදී ගැනීමෙන් නිර්මාතෘට සහාය වන්න නිර්මාතෘ කොමිසම විකුණුම්කරුවන් විසින් නියම කළ, හෝ මෙම බ්ලූප්‍රින්ට්හි නව අනුවාදයක් සාදා ආදායම බෙදා ගැනීමට ඔබේ බ්ලූප්‍රින්ට්හි සම්බන්ධතාවයක් ලෙස ඇතුළත් කරන්න.

සාකච්ඡාව

(0)

පිවිසෙන්න සාකච්ඡාවට එක්වීමට

අදහස් පූරණය කරමින්...