ပူးပေါင်းဆောင်ရွက်ခြင်း
အနုပညာ
အလှအပနှင့် ကျန်းမာရေး
လက်မှုအနုပညာ
ယဉ်ကျေးမှုနှင့် သမိုင်း
ဖျော်ဖြေရေး
ပတ်ဝန်းကျင်
အစားအစာနှင့် အချိုရည်
ပြောင်းပြန်အင်ဂျင်နီယာပညာ
သိပ္ပံပညာများ
အားကစား
နည်းပညာ
ဝတ်ဆင်နိုင်သောပစ္စည်းများ
Alcohol Burner: the Glass Spirit Lamp with a Copper Wick Shield (Morfit, 1849)
Charlie

ဖန်တီးသူ

Charlie

7. နိုဝင်ဘာ 2026DE
၃
၀
၀
၀
၀

Alcohol Burner: the Glass Spirit Lamp with a Copper Wick Shield (Morfit, 1849)

A small glass lamp that burns alcohol for heating test tubes and small vessels on the bench. Campbell Morfit (1849): the glass body holds the alcohol; a round copper shield with a tube in its centre carries a cotton wick and rests on the neck; a minute hole in the shield lets vapour escape; a glass cap ground to fit the neck keeps the alcohol from evaporating. Alcohol gives no smoke and does not blacken the glass. Sizes, and how the wick tube is fixed, are not given. Source: C. Morfit, Chemical and Pharmaceutic Manipulations (1849), pp. 160-162. Picture: Fig. 115.
အစပြု
Unknown

ညွှန်ကြားချက်များ

1

Read Morfit

"To the neck b is adjusted a copper circular shield c, with a tube in its centre for the passage of the wick, which should be of cotton, and similar to that used for tallow candles. The shield should rest upon, rather than within the neck, otherwise its expansion by the heat may cause the breakage of the glass. A minute opening drilled in the shield is also requisite for the escape of vapor in case the alcohol should become heated."
2

Make the copper shield

Cut a round copper shield a little wider than the neck of the glass body, so it rests on the neck and not inside it. Fix a short copper tube through its centre for the wick (ours: soldered; the joint is not given). Drill a minute hole in the shield for vapour to escape. Sizes are not given (unknown).

ဤအဆင့်အတွက် ကုန်ကြမ်းများ:

ကြေးနီပြားကြေးနီပြား1 shield
ကြေးနီပြွန်ကြေးနီပြွန်1 wick tube
သံဖြူ-ခဲဂဟေသံဖြူ-ခဲဂဟေ1 joint
ဖလပ်စ်ဖလပ်စ်1 joint

လိုအပ်သော ကိရိယာများ:

သံပြားညှပ်ကတ်ကြေးသံပြားညှပ်ကတ်ကြေး
ဂဟေဆော်တံဂဟေဆော်တံ
လက်တူးစက်လက်တူးစက်
မသိရှိသေးသော အတိုင်းအတာများမသိရှိသေးသော အတိုင်းအတာများ
3

Fit the wick and the body

Draw a cotton wick of the tallow-candle kind through the tube so it reaches down into the glass body, which is the alcohol reservoir. Set the shield on the neck. Ours: a clear glass bottle as the body.

ဤအဆင့်အတွက် ကုန်ကြမ်းများ:

ဖန်ပုလင်း (အရောင်မရှိ ကြည်လင်)ဖန်ပုလင်း (အရောင်မရှိ ကြည်လင်)1 body
ဝါဖယောင်းတိုင်မီးစာဝါဖယောင်းတိုင်မီးစာ1 ခု

လိုအပ်သော ကိရိယာများ:

သံပြားညှပ်ကတ်ကြေးသံပြားညှပ်ကတ်ကြေး
4

Fit the glass cap

Cover the wick, when the lamp is not in use, with a glass cap ground inside to fit the neck closely. It stops the alcohol evaporating and the wick taking up water, which makes relighting difficult. Put it on only after the lamp is out. How the cap is made and ground is not given (unknown).

ဤအဆင့်အတွက် ကုန်ကြမ်းများ:

မသိသော ဖန်မသိသော ဖန်1 cap

လိုအပ်သော ကိရိယာများ:

မသိရှိသေးသော အတိုင်းအတာများမသိရှိသေးသော အတိုင်းအတာများ
5

Fill and use

Morfit burns alcohol of about specific gravity 0.85. Always put the lamp out before refilling, then pour the spirit in gently until the reservoir is nearly full. The flame is hottest just below its tip; bring the vessel to it gradually, and spread the heat with copper gauze between flame and vessel for larger surfaces.

ပစ္စည်းများ

7

လိုအပ်သော ကိရိယာများ

4

ဤဘလူးပရင့်က ပြုလုပ်သည်

CC0 အများပိုင်

ဤအစီအစဉ်ကို CC0 အောက်တွင် ထုတ်ဝေထားသည်။ ခွင့်ပြုချက်မလိုဘဲ ကူးယူ၊ ပြင်ဆင်၊ ဖြန့်ဝေ နှင့် အသုံးပြုနိုင်သည်။

အစီအစဉ်မှတစ်ဆင့် ကုန်ပစ္စည်းများဝယ်ယူ၍ လက်မှုပညာရှင်ကို ပံ့ပိုးပါ လက်မှုပညာရှင် ကော်မရှင် ရောင်းချသူက သတ်မှတ်သည်၊ သို့မဟုတ် ဤအစီအစဉ်၏ ဗားရှင်းအသစ်ဖန်တီး၍ ဝင်ငွေခွဲဝေရန် သင့်အစီအစဉ်တွင် ချိတ်ဆက်မှုအဖြစ် ထည့်သွင်းပါ။

ဆွေးနွေးချက်

(0)

ဝင်ရောက် ဆွေးနွေးချက်တွင် ပါဝင်ရန်

မှတ်ချက်များ ရယူနေသည်...