အနုပညာ
အလှအပနှင့် ကျန်းမာရေး
လက်မှုအနုပညာ
ယဉ်ကျေးမှုနှင့် သမိုင်း
ဖျော်ဖြေရေး
ပတ်ဝန်းကျင်
အစားအစာနှင့် အချိုရည်
စိမ်းလန်းသောအနာဂတ်
ပြောင်းပြန်အင်ဂျင်နီယာပညာ
သိပ္ပံပညာများ
အားကစား
နည်းပညာ
ဝတ်ဆင်နိုင်သောပစ္စည်းများ
Purifying Water with a Natural Filter — Charcoal, Sand & Gravel
Build a three-layer water filter from charcoal, sand, and gravel. Important: always boil filtered water for 1 minute — filtration alone does not kill all pathogens.
Beginner
30-45 minutes
Instructions
1
1
Filter Layer Diagram
Filter Layer Diagram
Water flows top to bottom through three layers: charcoal (chemical filtration) → sand (physical filtration) → gravel (structural support). Always boil after filtering.
Flow
Loading...
2
2
Make Charcoal
Make Charcoal
Burn hardwood until fully black. Smother with sand to stop combustion. Cool, then crush to pea-sized pieces. ~2 cups needed.
3
3
Assemble Filter
Assemble Filter
Container (bark cone, hollow log, or cut bottle). Grass plug at drain. Layer: 5-8cm gravel, 8-10cm sand, 5-8cm charcoal, thin gravel cap on top.
Design
Cross-section: labeled layers with measurements
4
4
Filter & Boil
Filter & Boil
Pour water slowly. Discard first dark batch (charcoal dust). By third pass, water runs clear. ALWAYS boil 1 minute before drinking.
Materials
- •Charcoal (crushed) - 2 cupssPlaceholder
- •Fine sand - 3 cupssPlaceholder
- •Gravel - 2 cupssPlaceholder
- •Container - 1 piecePlaceholder
Tools Required
- FirePlaceholder
CC0 Public Domain
This blueprint is released under CC0. You are free to copy, modify, distribute, and use this work for any purpose, without asking permission.
Support the Maker by purchasing products through their Blueprint where they earn a Maker Commission set by Vendors, or create a new iteration of this Blueprint and include it as a connection in your own Blueprint to share revenue.