УРЛАГ
ГОО САЙХАН БА ЭРҮҮЛ МЭНД
ГАРААР ХИЙСЭН
СОЁЛ БА ТҮҮХ
ҮЗВЭР НААДАМ
БАЙГАЛЬ ОРЧИН
ХООЛ БА УНДАА
НОГООН ИРЭЭДҮЙ
УРВУУ ИНЖЕНЕРЧЛЭЛ
School Projects
ШИНЖЛЭХ УХААН
СПОРТ
ТЕХНОЛОГИ
ӨМСДӨГ ХЭРЭГСЭЛ

Building a Djembe — The West African Rope-Tuned Goblet Drum
Build a djembe: a goblet-shaped wooden drum with a goat-skin head, tuned not by heat but by PULLING ropes tight in a diamond weave. Carve the body, mount the skin on rings, then rope it up and tune it. A serious maker build in the membrane drum and rope tensioning, giving three voices — bass, tone and slap — from one head.
Дунд шат
Several hours over several sessions
Зааварчилгаа
1
1
A drum you tune with rope
A drum you tune with rope
The djembe is a goblet-shaped wooden drum with a goat-skin head. Instead of heating the skin to tune it, you pull ropes tight in a diamond weave — the tighter the rope, the higher and sharper the drum.
2
2
Carve the goblet body
Carve the goblet body
Hollow a goblet-shaped body — a wide bowl at the top narrowing to a stem and opening out at the foot. Traditionally it is carved from a single log; built up from wood, keep the bore smooth and the bottom fully open.
Materials for this step:
Dry Softwood Board1 ширхэг
PVA Wood Glue1 ширхэгTools needed:
Sloyd Carving Knife
Hacksaw3
3
Cut the head
Cut the head
Cut a round goat-skin rawhide head a good bit wider than the drum's bowl, with the hair scraped off.
Materials for this step:
Rawhide1 ширхэг4
4
Make two rings
Make two rings
Bend two metal rings that fit the drum's rim. Wrap one in the skin (the flesh ring) and leave one as a bottom ring; rows of rope loops hang from each.
Materials for this step:
Bronze Wire1 ширхэг
Abaca Tying Twine1 ширхэг5
5
Mount the skin
Mount the skin
Soak the skin, fold it over the top ring, and seat both over the bowl so the wet head lies across the mouth of the drum.
6
6
Rope it up
Rope it up
Lace a long rope up and down between the top ring's loops and the bottom ring, pulling the head down. Let it dry, then weave the verticals together in diamonds to pull them tighter still.
Materials for this step:
Abaca Tying Twine1 ширхэг7
7
Tune and play
Tune and play
Pull more diamonds to tighten the head and raise the pitch. Then play bare-handed: a deep BASS in the centre, a ringing TONE on the edge, and a sharp cracking SLAP with loose fingers on the rim.
8
8
Compendium — three voices and a tuning rope
Compendium — three voices and a tuning rope
The djembe is a goblet membrane drum, close kin to the darbuka, but two things set it apart. First, its body is a big carved WOODEN goblet, not clay: struck in the centre the head drives a slow pulse of air down the hollow stem and out of the open foot, which acts as a horn to boom the deep BASS; struck near the rim the edge of the skin snaps for a ringing TONE, and a loose, cracking hit gives the bright SLAP — three distinct voices from one head, the palette of West African drumming. Second, and cleverest, is how it is tuned. A drumhead's pitch rises with tension, and where the darbuka's skin is glued or warmed, the djembe's is pulled tight by ROPE: the head is trapped between two metal rings, and a long rope laced between them and then woven into diamonds draws the rings together and stretches the skin — pull more diamonds and the whole head tightens and the drum sings higher, all with no heat and no glue, tunable in a moment and re-tunable forever. This rope-lacing is the same idea that tunes the Korean janggu, and the djembe's goblet shape is the wooden cousin of the clay darbuka. Carved by the blacksmith-craftsmen of the Mande peoples for many centuries, the djembe is said to 'gather everyone in peace'.
Материал
5- 1 ширхэгPlaceholder
- 1 ширхэгPlaceholder
- 1 ширхэгPlaceholder
- 2 ширхэгPlaceholder
You can swap these in
Can't get one of the materials? Swap it for an equivalent — these work just as well.
- Instead of Abaca Tying Twine, try:
Cotton Twine (for bundling)
Binding Twine
Jute Twine - Instead of Sloyd Carving Knife, try:
Blunt Collection Knife
Gilder's Knife
Knife
Sharp Cinnamon Knife - Instead of PVA Wood Glue, try:
Polyurethane Glue - Instead of Bronze Wire, try:
Hook-Up Wire - Assortment (Stranded)
Tie Wire
Thin Brass Wire (for cleaning spouts)
Slip Ring - 6 Wire (2A)
Холбоотой загварууд
Эдгээр загварууд мэдлэг хуваалцдаг — арга техник, материал эсвэл зарчим
Related blueprints
Other builds that share materials, tools, or techniques with this one.

Building a Balafon — The West African Gourd-Resonated Xylophone

Building a Kora — The West African Harp-Lute

Building a Janggu — The Korean Hourglass Drum

Building a Talking Drum — West Africa's Squeeze-to-Speak Dùndún

Building a Langspil — The Icelandic Drone Zither

Building a Sheng — The Chinese Free-Reed Mouth Organ
CC0 Нийтийн домэйн
Энэ загвар CC0 дор гаргагдсан. Та зөвшөөрөл авахгүйгээр хуулах, өөрчлөх, түгээх, ашиглах боломжтой.
Загвараар дамжуулан бүтээгдэхүүн худалдаж авч Бүтээгчийг дэмжээрэй Бүтээгчийн шимтгэл Борлуулагчаар тогтоосон, эсвэл энэ загварын шинэ хувилбар үүсгэж орлогоо хуваахын тулд өөрийн загварт холбоос болгон оруулна уу.