Хамтын ажиллагаа
УРЛАГ
ГОО САЙХАН БА ЭРҮҮЛ МЭНД
ГАРААР ХИЙСЭН
СОЁЛ БА ТҮҮХ
ҮЗВЭР НААДАМ
БАЙГАЛЬ ОРЧИН
ХООЛ БА УНДАА
УРВУУ ИНЖЕНЕРЧЛЭЛ
ШИНЖЛЭХ УХААН
СПОРТ
ТЕХНОЛОГИ
ӨМСДӨГ ХЭРЭГСЭЛ
Liquid Hydrogen: Gas at 200 Atmospheres Cooled by Dry Ice and Liquid Air, then Expanded in a Regenerator Coil (Travers, 1901)
Charlie

Зохиогч

Charlie

1. Арван нэгдүгээр сар 2026DE
7
0
0
0
0

Liquid Hydrogen: Gas at 200 Atmospheres Cooled by Dry Ice and Liquid Air, then Expanded in a Regenerator Coil (Travers, 1901)

Hydrogen will not cool when it expands at room temperature, so Travers first chilled it with dry ice and then with liquid air boiling under a vacuum. Only then did expansion through a fine valve inside a regenerator coil cool it further, until clear liquid hydrogen ran into a vacuum vessel. Result: liquid hydrogen (specific gravity 0.06), cold enough to freeze air solid. Source: M. W. Travers, The Experimental Study of Gases (1901), pp. 196-206. Hydrogen is flammable; liquid air and liquid hydrogen are extremely cold. Picture: Fig. 103 of the book.
Дээд шат
1 week

Зааварчилгаа

1

Make and store the hydrogen

Put about 40 lb of commercial granulated zinc in a beer cask with a tap funnel, a delivery tube, an escape pipe into a vessel of water (safety valve) and a stoneware cock at the bottom to draw off spent acid. Run in dilute sulphuric acid. When the air is out, pass the gas through a wash-bottle of potassium permanganate into the gasometer (sheet iron, 6 ft high, 5 ft 6 in across, over water first saturated with hydrogen). Wash the gasometer out with hydrogen before collecting the main quantity. This takes five hours.

Энэ алхмын материал:

УстөрөгчУстөрөгч1 a gasometer full, made here

Шаардлагатай багаж:

ЦайрЦайр
Шингэрүүлсэн хүхрийн хүчилШингэрүүлсэн хүхрийн хүчил
Модон торхМодон торх
Дусаагуур юүлүүрДусаагуур юүлүүр
Калийн перманганатКалийн перманганат
Хий угаах колбХий угаах колб
Хийн савХийн сав
УсУс
2

Make liquid air and ready the compressor

In the two or three days before, use the compressor to make liquid air with the Hampson liquefier and store it in vacuum vessels, about 8 litres in all. Then take the compressor apart and check the valves, springs and fibre packings. Remove the Hampson machine and connect the compressor through the cylinder of caustic potash to the hydrogen liquefier.

Шаардлагатай багаж:

Хий шахагчХий шахагч
Хэмпсоны агаар шингэрүүлэгчХэмпсоны агаар шингэрүүлэгч
Шингэн агаарШингэн агаар
Вакуум сав (Дьюар)Вакуум сав (Дьюар)
3

Cool the liquefier

Four people are needed. Pack the vessel round coil A with solid carbonic acid and alcohol (-80 °C). Pour liquid air into chamber B and let it into chamber C, pumped down to 100 mm of mercury so it boils below -200 °C. Draw liquid air into vacuum vessel H and boil it under reduced pressure to chill the regenerator coil below -200 °C, then let it out and put vessels K and M (with a little liquid air) back in place.

Шаардлагатай багаж:

Устөрөгч шингэрүүлэгчУстөрөгч шингэрүүлэгч
Хатуу нүүрстөрөгчийн давхар исэлХатуу нүүрстөрөгчийн давхар исэл
Денатурчилсан этанол, 95 %Денатурчилсан этанол, 95 %
Шингэн агаарШингэн агаар
Вакуум сав (Дьюар)Вакуум сав (Дьюар)
Вакуум насосВакуум насос
Вакуум хэмжүүрВакуум хэмжүүр
4

Compress the hydrogen to 200 atmospheres

Purge the air from the compressor: open cock a, run a few turns, stop and open cock rho; do this three or four times. Then raise the pressure. The first cylinder takes the gas to about 16 atm, with a little glycerol and water holding 5 % caustic soda as lubricant; the second takes it to about 200 atm. The water is separated out and the gas dried over lumps of solid caustic potash. Have it at 200 atm by the time the liquefier is cold.

Шаардлагатай багаж:

Хий шахагчХий шахагч
ГлицеролГлицерол
Каустик сод (натрийн гидроксид)Каустик сод (натрийн гидроксид)
УсУс
Калийн гидроксидКалийн гидроксид
Даралтын хэмжүүрДаралтын хэмжүүр
5

Expand and collect the liquid

Reconnect chamber C to the exhaust pump and let liquid air in slowly (a fall of the mercury in the vacuum gauge means too fast). Open the expansion valve with the milled nut; let the gas out through the water tank for a few moments to clear the air, then open cock i so it circulates back. Keep B and the coil-A vessel topped up. Watch the glycerol gauge for the flow and turn the milled nut slowly back and forth the whole time so it does not block. H coats with white solid air; open cock r now and then, and the liquid runs through a baize filter into K. Lift K out on its wire into a vessel with a little liquid air. About 10 % of the gas is lost per run.

Шаардлагатай багаж:

Устөрөгч шингэрүүлэгчУстөрөгч шингэрүүлэгч
Шингэн агаарШингэн агаар
Хатуу нүүрстөрөгчийн давхар исэлХатуу нүүрстөрөгчийн давхар исэл
Вакуум сав (Дьюар)Вакуум сав (Дьюар)
Вакуум насосВакуум насос
Вакуум хэмжүүрВакуум хэмжүүр
Даралтын хэмжүүрДаралтын хэмжүүр

Материал

1
  • 1 a gasometer full, made here
    Түр орлуулагч

Шаардлагатай багаж

21

CC0 Нийтийн домэйн

Энэ загвар CC0 дор гаргагдсан. Та зөвшөөрөл авахгүйгээр хуулах, өөрчлөх, түгээх, ашиглах боломжтой.

Загвараар дамжуулан бүтээгдэхүүн худалдаж авч Бүтээгчийг дэмжээрэй Бүтээгчийн шимтгэл Борлуулагчаар тогтоосон, эсвэл энэ загварын шинэ хувилбар үүсгэж орлогоо хуваахын тулд өөрийн загварт холбоос болгон оруулна уу.

Хэлэлцүүлэг

(0)

Нэвтрэх хэлэлцүүлэгт нэгдэхийн тулд

Сэтгэгдлүүдийг ачаалж байна...