УРЛАГ
ГОО САЙХАН БА ЭРҮҮЛ МЭНД
ГАРААР ХИЙСЭН
СОЁЛ БА ТҮҮХ
ҮЗВЭР НААДАМ
БАЙГАЛЬ ОРЧИН
ХООЛ БА УНДАА
УРВУУ ИНЖЕНЕРЧЛЭЛ
ШИНЖЛЭХ УХААН
СПОРТ
ТЕХНОЛОГИ
ӨМСДӨГ ХЭРЭГСЭЛ
Nalbinding a Wool Sock in the Oslo Stitch — The Looped Fabric Before Knitting
Long before knitting, people made warm, hard-wearing socks and mittens by nalbinding — looping short lengths of wool with a single flat needle. Unlike knitting, which pulls loops through loops with two rods and can unravel, nalbinding passes the whole working thread through each stitch, giving a dense, felt-firm fabric that will not run. This blueprint works the simple Oslo stitch into a tube for a sock or mitten, joining new wool with a felted splice rather than a knot — exactly as the Vikings did.
Дунд шат
4
Зааварчилгаа
1
1
Cut a short working length
Cut a short working length
Cut about an arm's length of wool yarn — not a whole ball. In nalbinding the entire length is pulled through every stitch, so you work with short pieces and splice on more as needed.
Энэ алхмын материал:
Wool Yarn Skein1 ширхэгШаардлагатай багаж:
Sharp Scissors2
2
Thread the flat needle
Thread the flat needle
Thread the yarn through the eye of the flat nalbinding needle. The needle is broad, blunt and eyed at one end — bone, antler or wood — and never has a hook.
Шаардлагатай багаж:
Nalbinding Needle3
3
Make the foundation loops
Make the foundation loops
Loop the yarn around your thumb and make a short chain of starting loops. These foundation loops are the base row that every following stitch will anchor into.
Шаардлагатай багаж:
Nalbinding Needle4
4
Work the Oslo stitch
Work the Oslo stitch
Pass the needle under the thumb loop and up through the working loop to form the Oslo stitch — the simplest nalbinding stitch. Draw each stitch snug and even, building the first row.
Шаардлагатай багаж:
Nalbinding Needle5
5
Join into a round
Join into a round
For a sock or mitten, connect the ends of the first row into a ring by stitching the last stitch into the first, so you can then work round and round to form a tube.
Шаардлагатай багаж:
Nalbinding Needle6
6
Work in a spiral
Work in a spiral
Continue in a spiral, anchoring each new Oslo stitch into the loop of the row below. Keep the tension steady so the tube grows even in width — this becomes the leg of the sock.
Шаардлагатай багаж:
Nalbinding Needle7
7
Splice in new yarn
Splice in new yarn
When the length runs short, join a new piece with a felted splice, not a knot: untwist and overlap the two wool ends, wet them, and roll them briskly between your palms until the fibres felt into one continuous thread.
Энэ алхмын материал:
Wool Yarn Skein1 ширхэгШаардлагатай багаж:
Nalbinding Needle8
8
Shape the tube
Shape the tube
Increase by working two stitches into one loop and decrease by skipping a loop, shaping the tube — narrowing for an ankle, turning a heel, or rounding a mitten — as the piece requires.
Шаардлагатай багаж:
Nalbinding Needle9
9
Close the toe
Close the toe
At the end, decrease steadily until only a few loops remain, then pass the needle through them and draw them tight to close the toe or mitten tip.
Шаардлагатай багаж:
Nalbinding Needle10
10
Secure and trim the tail
Secure and trim the tail
Weave the final yarn tail back through several stitches on the inside to lock it, then trim it flush. Because the fabric is looped, not knitted, it cannot unravel from the cut end.
Шаардлагатай багаж:
Nalbinding NeedleSharp ScissorsМатериал
1- 1 ширхэгТүр орлуулагч
Холбогдсон загварын материал
Холбоотой загварууд
Эдгээр загварууд мэдлэг хуваалцдаг — арга техник, материал эсвэл зарчим
CC0 Нийтийн домэйн
Энэ загвар CC0 дор гаргагдсан. Та зөвшөөрөл авахгүйгээр хуулах, өөрчлөх, түгээх, ашиглах боломжтой.
Загвараар дамжуулан бүтээгдэхүүн худалдаж авч Бүтээгчийг дэмжээрэй Бүтээгчийн шимтгэл Борлуулагчаар тогтоосон, эсвэл энэ загварын шинэ хувилбар үүсгэж орлогоо хуваахын тулд өөрийн загварт холбоос болгон оруулна уу.