ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE

Jo Dusepo · CC BY-SA 4.0
Building a Langspil — The Icelandic Drone Zither
Build Iceland's traditional drone zither: a long wooden soundbox with one fretted melody string and two drone strings that ring constantly beneath the tune, so a single player makes melody and harmony at once. A serious maker build in the drone zither and how a soundbox amplifies strings.
Intermedio
Several hours over a few sessions
Instrucciones
1
1
Melody and drone from one box
Melody and drone from one box
The langspil is Iceland's drone zither: a long soundbox with one fretted melody string and one or two drone strings that ring under every note, so one player sounds a tune AND its harmony at once.
2
2
Cut the soundbox parts
Cut the soundbox parts
Cut a base, two side ribs and two end blocks for a long, narrow box about 80 cm long and 8-10 cm wide. Icelanders used driftwood — pine, birch or oak.
Materiales para este paso:
Baltic Birch Plywood (1/8 inch, 12x12, 10-Pack)1 piezaHerramientas necesarias:
Hacksaw3
3
Glue the box frame
Glue the box frame
Glue the two ribs to the base and end blocks to make a long, shallow open box. Clamp it and let the glue set fully.
Materiales para este paso:
PVA Wood Glue1 pieza4
4
Fit the soundboard
Fit the soundboard
Glue a thin softwood soundboard over the top, overlapping the ribs slightly, to seal a resonant chamber. A thin, light top vibrates best.
Materiales para este paso:
Dry Softwood Board1 pieza
PVA Wood Glue1 pieza5
5
Cut a soundhole
Cut a soundhole
Cut a round soundhole in the soundboard so the sound built up inside the box can escape.
Herramientas necesarias:
Sloyd Carving Knife6
6
Drill the peg holes
Drill the peg holes
At the headstock end, bore three tapered holes through the top for the tuning pegs — one for the melody string, two for the drones.
Herramientas necesarias:
Awl7
7
Fit the tuning pegs
Fit the tuning pegs
Push a friction tuning peg into each hole so it turns stiffly and holds string tension without slipping.
Materiales para este paso:
Tuning Pegs3 piezas8
8
Carve the nut and bridge
Carve the nut and bridge
Carve a small hardwood nut near the pegs and a low bridge near the far end. The strings ride over both, lifted clear of the soundboard.
Herramientas necesarias:
Sloyd Carving Knife9
9
String it
String it
Anchor three steel strings to small pins at the far end, run them over the bridge and nut, and wind each onto its tuning peg.
Materiales para este paso:
Steel Music Wire1 pieza10
10
Set the frets
Set the frets
Fit small metal frets across the soundboard UNDER THE MELODY STRING ONLY, spaced so pressing behind each one gives the next note of a diatonic scale.
Materiales para este paso:
Fret Wire1 piezaHerramientas necesarias:
Metal File11
11
Tune the drones
Tune the drones
Tune the two drone strings to a low keynote and its octave or fifth. They will sound continuously, giving the langspil its droning voice.
12
12
Tune the melody string
Tune the melody string
Tune the melody string to the keynote too. Check it against the frets — pressing behind each fret should climb cleanly through the scale.
13
13
Play it
Play it
Press the melody string behind the frets with one hand and pluck it with the other. The drones ring under every note. Try bowing or gently hammering it too.
14
14
Compendium — the drone zither
Compendium — the drone zither
The langspil is a drone zither: a resonant box with strings stretched along the top. One fretted MELODY string carries the tune while one or two DRONE strings hold a constant note, so a single player produces melody and harmony together — the same principle as a bagpipe's chanter over its drones, or a hurdy-gurdy. The sealed soundbox is a resonator: the thin strings alone move almost no air, but they shake the light soundboard, which drives the air inside the box, which spills out through the soundhole — the box amplifies the strings, exactly as in a guitar or violin. String pitch follows the same three rules as the musical bow — tension, length and mass — and pressing the melody string just behind a fret shortens its speaking length to raise the pitch by a fixed step, which is the whole point of the frets. Iceland has few trees, so langspils were built from driftwood — pine, birch, oak; the instrument is first recorded in the 18th century and is a northern cousin of the German scheitholt and the Appalachian dulcimer, all box drone zithers. Icelandic schoolchildren still build and play their own today, some laser-cut from plywood in a Fab Lab — a heritage instrument kept alive by making it.
Materiales
6- Marcador de posición
- 2 piezasMarcador de posición
- 1 piezaMarcador de posición
- 3 piezasMarcador de posición
- 1 piezaMarcador de posición
Blueprints relacionados
Estos blueprints comparten conocimiento — técnicas, materiales o principios
CC0 Dominio público
Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.
Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.

