ARTE
BELLEZA Y BIENESTAR
ARTESANÍA
CULTURA E HISTORIA
ENTRETENIMIENTO
MEDIO AMBIENTE
COMIDA Y BEBIDAS
FUTURO VERDE
INGENIERÍA INVERSA
CIENCIAS
DEPORTES
TECNOLOGÍA
TECNOLOGÍA VESTIBLE
Building a Khaen — The Lao Free-Reed Mouth Organ
Woody

Creado por

Woody

3. julio 2026NO
0
0
0
0
0

Building a Khaen — The Lao Free-Reed Mouth Organ

Build a khaen, the national instrument of Laos: a flat raft of long paired bamboo pipes passing through a small hardwood windchest, each voiced by a springy metal free reed. Cover a pipe's hole and it sounds; hold some for a drone while others play a tune — and it sings on both blow and draw. A serious maker build in the free reed, in raft form.
Intermedio
Several hours over a few sessions

Instrucciones

1

A raft of singing bamboo

The khaen is the free-reed mouth organ of Laos and northeast Thailand: long bamboo pipes laid flat in a raft through a small windchest. Blow or draw, cover the holes, and it pours out drones and melody at once for mor lam music.
2

Cut the pipes

Cut a set of long, thin bamboo pipes in graduated lengths and lay them in two neat rows — a raft. Fourteen to sixteen pipes make a full khaen; start with fewer.

Materiales para este paso:

BambooBamboo1 pieza

Herramientas necesarias:

HacksawHacksaw
3

Carve the windchest

Carve a small hardwood block into a hollow windchest with a mouth-hole at one end. The whole raft of pipes will pass through this chest.

Materiales para este paso:

Bloodwood BoardBloodwood Board1 pieza

Herramientas necesarias:

Sloyd Carving KnifeSloyd Carving Knife
4

Make the free reeds

From thin metal, cut a tiny free tongue for each pipe — a springy strip that swings cleanly through a matching slot, fixed at one end and free at the other.

Materiales para este paso:

Brass Shim (Reed Stock)Brass Shim (Reed Stock)1 pieza

Herramientas necesarias:

Metal FileMetal File
5

Mount a reed in each pipe

Set a reed into each pipe at the point where the pipe will cross inside the windchest, sealed airtight, with the tongue free to swing.

Materiales para este paso:

BeeswaxBeeswax1 pieza
6

Seal the pipes into the windchest

Pass all the pipes through the windchest so their reeds sit inside it, and seal every gap with black wax so no air can escape except through the reeds.

Materiales para este paso:

BeeswaxBeeswax1 pieza
7

Cut a finger hole in each pipe

Cut one finger hole in each pipe, just outside the windchest. This hole is the on/off switch for that pipe's note.

Herramientas necesarias:

AwlAwl
8

Test a pipe

Cup the windchest to your mouth, blow gently, and cover one pipe's hole. Covering the hole drives the air through that pipe's reed, and it sounds.
9

Drone and switch

An open hole lets air escape and stays silent; a covered hole sings. Hold a couple of holes covered for a constant drone while your other fingers pick out notes.
10

Tune the reeds

Add a dab of wax to a reed's tip to LOWER its note, or file the tip thinner to RAISE it, tuning the pipes to the khaen's seven-note scale.

Materiales para este paso:

BeeswaxBeeswax1 pieza

Herramientas necesarias:

Metal FileMetal File
11

Play drone and melody

Hold a drone under a running melody and breathe IN as well as out — free reeds sound both ways, so the khaen never has to stop for breath. That endless ripple is the sound of mor lam.
12

Compendium — the free reed, in a raft

The khaen works on the free reed, exactly like the Chinese sheng: a thin metal tongue that swings freely back and forth THROUGH a close-fitting slot as air flows past, chopping the airflow into a steady tone at the tongue's own pitch and speaking equally whether you blow or draw. But where the sheng gathers short pipes upright in a gourd bowl, the khaen lays long paired bamboo pipes flat in a raft that runs through a small hardwood windchest cupped in both hands — a different shape for the same idea, spread across Asia. Each pipe holds one reed, and its finger hole is a switch: only a covered hole forces air through the reed, so a player can hold some holes down for a continuous drone while other fingers pick out a melody above it, with no pause to breathe — the endlessly rippling texture of Lao and Isan mor lam song. The reeds are tuned by filing them thinner to raise the pitch or loading their tips with a dab of wax to lower it, set to the khaen's seven-note scale, and the whole windchest is sealed with black insect wax so that every breath goes only through the reeds. The free reed that both the khaen and the sheng are built on is the ancestor of the Western harmonica, accordion and reed organ, and its distant cousin is the plucked tongue of the jaw harp. The national instrument of Laos, the khaen is recognised by UNESCO as part of humanity's living heritage.

Materiales

4

Herramientas requeridas

4

You can swap these in

Can't get one of the materials? Swap it for an equivalent — these work just as well.

Blueprints relacionados

Estos blueprints comparten conocimiento — técnicas, materiales o principios

CC0 Dominio público

Este Blueprint se publica bajo CC0. Eres libre de copiar, modificar, distribuir y usar este trabajo para cualquier propósito, sin pedir permiso.

Apoya al Maker comprando productos a través de su Blueprint, donde gana una Comisión del Maker establecida por los vendedores, o crea una nueva iteración de este Blueprint e inclúyela como conexión en tu propio Blueprint para compartir ingresos.

Discusión

(0)

Iniciar sesión para unirte a la discusión

Cargando comentarios...