
GPS Position Logger
Arahan
Solder the GPS shield headers
Solder the GPS shield headers
The kit contains the shield, an EM-506 receiver with its interface cable, and R3 headers. Solder the headers to the shield.
Bahan untuk langkah ini:
SparkFun GPS Shield Kit1 kitAlatan diperlukan:
Ryobi ONE+ RSI18-0 Cordless Soldering IronStack both shields and check for pin clashes
Stack both shields and check for pin clashes
Plug the EM-506 into the shield's connector, then stack GPS shield and microSD shield on the Uno.
- GPS shield: receiver on D2/D3 with its switch in the DLINE position.
- microSD shield: SPI on D11/D12/D13, card select on D8.
Bahan untuk langkah ini:
microSD Shield1 keping
Arduino Uno R3 SMD1 kepingPower, and read raw NMEA before parsing anything
Power, and read raw NMEA before parsing anything
USB-B from the computer while testing; 7–12 V on the barrel jack once it runs standalone.
Before writing any parser, print the receiver's output straight through and look at it. You should see comma-separated sentences beginning with $.
Sentences arriving with empty position fields mean the receiver is alive and talking but has no fix yet. That is the normal cold-start state — not a fault.Bahan untuk langkah ini:
USB-B Cable1 kepingUpload the logging sketch
Upload the logging sketch
No GPS library needed — the sketch reads NMEA directly, so nothing is hidden behind an abstraction. SD and SPI ship with the IDE. Format the card FAT32 first.
Take it outside for the first fix
Take it outside for the first fix
Put the unit under open sky, powered, and leave it. Watch for the fix indicator before judging the build.
Testing a GPS receiver indoors and concluding it is broken is the single most common failure in this project. A cold start with no stored almanac legitimately takes minutes.Bahan
4- $54.00
- 1 keping$14.00
- 1 keping$27.00
- $6.00
Alatan Diperlukan
1CC0 Domain Awam
Blueprint ini dikeluarkan di bawah CC0. Anda bebas menyalin, mengubah, mengedar, dan menggunakan karya ini untuk sebarang tujuan, tanpa meminta kebenaran.
Sokong Pembuat dengan membeli produk melalui Blueprint mereka di mana mereka memperoleh Komisen Pembuat ditetapkan oleh Penjual, atau cipta iterasi baru Blueprint ini dan sertakan ia sebagai sambungan dalam Blueprint anda sendiri untuk berkongsi hasil.