SINING
BEAUTY AT WELLNESS
CRAFTS
KULTURA AT KASAYSAYAN
LIBANGAN
KAPALIGIRAN
PAGKAIN AT INUMIN
REVERSE ENGINEERING
AGHAM
ISPORTS
TEKNOLOHIYA
MGA WEARABLE
Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass
Charlie

Nilikha ni

Charlie

24. Setyembre 2026DE
23
0
0
0
0

Getting the Solid Back: Evaporate, Crystallise, and Dry to Constant Mass

Boiling a solution dry gives you everything that was dissolved in it, including the impurities. Letting it crystallise slowly gives you the substance you wanted and leaves most of the impurities in the liquid — because a growing crystal is fussy about what it lets in. So evaporating to dryness and crystallising are not two ways of doing the same job. The first is for recovering everything; the second is for purifying. Then there is the question of when it is actually DRY, which cannot be answered by looking. The answer is a measurement loop: dry, weigh, dry again, weigh again, and stop when the mass stops changing.
Katamtaman
3 hours

Mga Tagubilin

1

Evaporate gently, and never to the last drop over heat

Use a wide, shallow evaporating dish rather than a beaker: evaporation happens at the surface, so the area is what sets the speed, and a wide dish is faster at a much lower temperature. Stop while a little liquid remains and let the rest go at room temperature. Once the liquid is nearly gone there is nothing left to absorb the heat, the solid overheats in seconds, and it spits, decomposes or bakes onto the dish. A steam bath or a hot plate on a low setting is better than a flame for anything that matters. Direct flame heats one spot far above the boiling point of the solution, and many substances that survive 100 degrees do not survive that.

Mga materyales para sa hakbang na ito:

Distiladong TubigDistiladong Tubig1 litro
Sodium chloride (asin)Sodium chloride (asin)1 piraso

Mga kailangang kasangkapan:

Platong PansingawPlatong Pansingaw
Pang-init na PlatoPang-init na Plato
Salaming pang-orasanSalaming pang-orasan
2

Crystallise slowly, and crystallise on purpose

Dissolve the solid in the smallest volume of hot solvent that will take it, then let it cool UNDISTURBED. Slow cooling grows few, large, pure crystals; rapid cooling or stirring gives a mass of tiny ones that trap the mother liquor and everything dissolved in it. If nothing appears, it is usually because there is too much solvent or because there is no nucleus to start on. Boil a little solvent off, scratch the inside of the glass with a rod at the surface, or add one seed crystal. Then filter the crystals off cold and rinse them with a SMALL amount of ICE-COLD solvent. Rinsing with warm solvent dissolves the product you just spent an hour growing, which is the most disheartening way to lose a yield.

Mga materyales para sa hakbang na ito:

Distiladong TubigDistiladong Tubig1 litro
Copper sulfate pentahydrate (CuSO4·5H2O)Copper sulfate pentahydrate (CuSO4·5H2O)1 piraso

Mga kailangang kasangkapan:

Basong Salamin na Pang-aghamBasong Salamin na Pang-agham
Panghalong SalaminPanghalong Salamin
Embudong Büchner (porselana)Embudong Büchner (porselana)
Papel na PansalaPapel na Pansala
3

Dry to constant mass, which is a measurement not a judgement

Naglo-load ng Jupyter notebook…

Mga materyales para sa hakbang na ito:

Sodium chloride (asin)Sodium chloride (asin)1 piraso

Mga kailangang kasangkapan:

Hurnong pantuyoHurnong pantuyo
Salaming desiccatorSalaming desiccator
Tumpak na TimbanganTumpak na Timbangan
Desktop na KompyuterDesktop na Kompyuter
4

Work out the yield, and be honest about it

Percentage yield is what you got divided by what the equation says you could have got. Both numbers have to be real: the mass actually recovered and dried, and the theoretical mass calculated from the LIMITING reagent. Yields above 100% mean the product is not dry, or it has picked up something. That is worth treating as a fault rather than a bonus, because a wet product weighs more and is worth less. Record where the losses went, in the notebook: left in the mother liquor, stuck to the filter paper, lost in the rinse, spilled. Those lines are what make the next attempt better, and a yield with no explanation attached is a number nobody can improve.

Mga kailangang kasangkapan:

Tumpak na TimbanganTumpak na Timbangan
KalkuladorKalkulador

Mga Materyales

3

Mga Kinakailangang Kasangkapan

12

CC0 Pampublikong Domain

Ang blueprint na ito ay inilabas sa ilalim ng CC0. Malaya kang kumopya, magbago, mamahagi, at gumamit nang walang pahintulot.

Suportahan ang Maker sa pamamagitan ng pagbili ng mga produkto sa kanilang Blueprint Komisyon ng Maker itinakda ng mga Vendor, o lumikha ng bagong bersyon ng Blueprint na ito at isama bilang koneksyon sa iyong Blueprint upang ibahagi ang kita.

Talakayan

(0)

Mag-login upang sumali sa talakayan

Naglo-load ng mga komento...